Abstract:Accurate measurement of the downwash flow field of plant protection unmanned aerial vehicles (UAVs) is essential for analyzing the spatial distribution of droplets. To realize on-line rapid detection of the downwash flow field of a multi-rotor UAV, a flexible polypropylene detection device based on the principle of full bridge strain effect was proposed. Its performance principle was based on the physical deformation caused by wind pressure. The Fluid Flow and Static Structural modules of ANSYS 16.0 finite element software were used to simulate one-way fluid-solid coupling interaction. The surface of the resistive strain gauge embedded in the flexible detecting structure responded well to wind speed variation, hence it was suitable for downwash airflow wind field detection. By solving the strain force on the surface of the flexible detection structure, the length and layout of the grating wire of the strain gauge on the surface of the flexible detection structure were optimized. Meanwhile at 4 m·s−1 wind speed, the output voltage at varied bridge flexible acquisition systems in the acquisition card was measured. Results indicated coefficient of variation of 3.67%, 1.63% and 1.5%, respectively, which proved the good data acquisition consistency of the system. Through calibration test, the regression equation for the relationship between output voltage and wind speed for three unique sensor signal measuring circuits was established. The determination coefficients R2 for single bridge, half bridge and full bridge circuits were 0.9885, 0.9866 and 0.9959, respectively. In conclusion, by applying the multi-rotor plant protection UAV test platform, the results indicated the maximum relative error of the wind speed at each sampling point of the system at 1.0 m altitude was below 5.61%. Simulated and measured value had an RMSE maximum error of 0.1246 m·s−1. Moreover, downwash airflow detection not only has high accuracy but also has high sensitivity. Thus, there is convenience and practicability in the plant protection offered by this approach. The rapid measurement of UAV wind field and the established two-dimensional wind field model can provide a basis for precise application of agricultural aviation.

Simulation and Optimization Design of Atmospheric Detection Equipment Layout Based on UAV

A design for hardware of wind measuring system on meteorological UAV based on the improved model

Large-Sized Multirotor Design: Accurate Modeling with Aerodynamics and Optimization for Rotor Tilt Angle

Flow Structure around a Multicopter Drone: A Computational Fluid Dynamics Analysis for Sensor Placement Considerations

Target Detection Formulti-Uavs Via Digital Pheromones and Navigation Algorithm in Unknownenvironments

A Multi-UAV cooperative mission planning method based on SA-WOA algorithm for three-dimensional space atmospheric environment detection

Water Quality Sampling and Multi-Parameter Monitoring System Based on Multi-Rotor UAV Implementation

Design of Autonomous Bolt Detection System Based on Quadrotor UAV

Optimization of sampling structure on unmanned aerial vehicle for gas leakage monitoring in the atmosphere

Design of Variable Spray System for Plant Protection UAV Based on CFD Simulation and Regression Analysis

Correction of Error of Airborne Anemometers Caused by Self-Excited Air Turbulence

Design and Field Campaign Validation of a Multirotor UAV and Optical Particle Counter

Design of UAV Downwash Airflow Field Detection System Based on Strain Effect Principle

Meteorology-Aware Path Planning for the UAV Based on the Improved Intelligent Water Drops Algorithm

DOB-based Wind Estimation of A UAV Using Its Onboard Sensor

Design Automation and Optimization Methodology for Electric Multicopter UAVs

Wind Pressure Orthogonal Decomposition Anemometer: A Wind Measurement Device for Multi-Rotor UAVs

CFD simulation and experimental verification of the spatial and temporal distributions of the downwash airflow of a quad-rotor agricultural UAV in hover

Development of Fixed-Wing UAV 3D Coverage Paths for Urban Air Quality Profiling

An optimized multicopter UAV sounding technique (MUST) for probing comprehensive atmospheric variables

A Simulation Framework of Unmanned Aerial Vehicles Route Planning Design and Validation for Landslide Monitoring