Abstract:In an effort to address the load adjustment time in the thermal and electrical load distribution of thermal power plant units, we propose an optimal load distribution method based on load prediction among multiple units in thermal power plants. The proposed method utilizes optimization by attention to fine-tune a deep convolutional long-short-term memory network (CNN-LSTM-A) model for accurately predicting the heat supply load of two 30 MW extraction back pressure units. First, the inherent relationship between the heat supply load and thermal power plant unit parameters is qualitatively analyzed, and the influencing factors of the power load are screened based on a data-driven analysis. Then, a mathematical model for load distribution optimization is established by analyzing and fitting the unit's energy consumption characteristic curves on the boiler and turbine sides. Subsequently, by using a randomly chosen operating point as an example, a genetic algorithm is used to optimize the distribution of thermal and electrical loads among the units. The results showed that the combined deep learning model has a high prediction accuracy, with a mean absolute percentage error (MAPE) of less than 1.3%. By predicting heat supply load variations, the preparedness for load adjustments is done in advance. At the same time, this helps reduce the real-time load adjustment response time while enhancing the unit load's overall competitiveness. After that, the genetic algorithm optimizes the load distribution, and the overall steam consumption rate from power generation on the turbine side is reduced by 0.488 t/MWh. Consequently, the coal consumption rate of steam generation on the boiler side decreases by 0.197 kg (coal)/t (steam). These described changes can greatly increase the power plant's revenue by CNY 6.2673 million per year. The thermal power plant used in this case study is in Zhejiang Province, China.

Load allocation optimization during shutdown of combined-cycle units

Research on Optimization of Residual Natural Gas Distribution for Combined Cycle Unit Shutdown Process

Modeling and optimization of shutdown process of combined cycle gas turbine under limited residual natural gas

Coordinated Emergency Load Shedding Control Optimization Algorithm for Economic Cost and Accident Assessment

Load Optimal Distribution for Power Plants with Consideration of Environmental Costs

Optimization of Start-up Process in Combined Cycle Steam Turbine of a Power Plant

Optimization on Start-up Process of Steam Turbine in Combined Cycle Generating Units

Optimization on plant-level AGC coal consumption curve based on operation mode of pulverizing systems

Capacity configuration optimization for the CCHP system considering integrated demand response

Annual rolling generation scheduling and unit commitment optimization model based on open and impartial dispatching

ANALYSIS OF RETROFITTING SCHEME FOR A COMBINED CYCLE WITH BOILER USING EXHAUST GAS FOR SUPPORTING COMBUSTION

Impact of the Running Modes of Coal-Fired Units on Energy Consumption in in-Depth Peak Load Cycling

Modular Modeling and Trust Region Based Real-Time Optimization for Load Changes in Modular High Temperature Gas-Cooled Reactor

Optimal Load Distribution of CHP Based on Combined Deep Learning and Genetic Algorithm

Optimization of Load Distribution Method for Hydropower Units Based on Output Fluctuation Constraint and Double-Layer Nested Model

Effect of device models on the multiobjective optimal operation of CCHP microgrids considering shiftable loads

Operational optimization on large‐scale combined heat and power units with low‐pressure cylinder near‐zero output

Configuration Method for Combined Heat and Power Plants with Flexible Electricity Regulation

Study of internal economic operation based on GA and operation region partition

A New Opportunistic Maintenance Optimization Model for Power Generating Unit

Optimal Load Distribution Based on Maximization of Comprehensive Economic Benefit in Power Plant