Abstract:The impulse wave generator was constructed for evaluation of the electromagnetic compatibility (EMC) of electronic and electrical devices. In the process of test, a combined wave generator is regularly used which can generate not only certain voltage waves, but also certain current waves. However, the design of this circuit is relatively difficult. This paper describes a method to design the combined wave generator. The method introduces two universal variables used to calculate the modulus decays and frequency of the wave, then gets the circuit parameters by calculation. It can be briefly expressed as, waveform parameters are ultilized to specify universal variables, which can be used to define the parameters of different circuit elements. The paper also discusses how to select the parameters in two usually adopted circuits. Moreover, the relationships between the parameters of the circuit and wave front and tail are pointed out. At last, the predominate factors which can greatly change the front and tail are found out: the inductors always influence front and the capacitors and resistors influence both front and tail. By the simulation with the Pspice software and the experiments of several impulse circuits, the method is demonstrated to be credible. Conclusions are drawn that,with this method, the selection of generator parameters turns out to be more reasonable and efficient. The method to design a combined wave generator conforms to relative IEC standard, which means the method can be applied for design.

Investigation of Influence of Coupling Capacitor on the Impulse Current of Combination Waveform Generator

Influence of Coupling Mode on Output Characteristics of Combination Wave Generator of Surge Protective Device

Analysis of the Conduction Process for Active Surge Protection Gap with Combination Wave Energy Injection

Theoretical Calculation Applied in Circuit Parameters of Combination Wave Generator for SPD Charging Test

A Parameter Design Method for High Performance LCLC-LC Compensated CPT Systems

Simulation of Combination Waveform Generator for ZnO Varistors

Coupling Analysis of Shielded and Unshielded Star Quad Cables Excited by an Intentional Electromagnetic Pulse

Influence of Parameter Uncertainty in Traveling-wave Differential Protection

Experimental Study of Transformer Coupling SSFCL with Capacitance Load

Coupling Capacitor Structure Model of Underwater Capacitive Wireless Power Transfer System

Measurement and analysis of high speed high voltage ultrashort pulse on capacitive load

Influences of Capacitance Value Changing in Explosive Magnetic Frequency Generator

Coupling and Decoupling Network(CDN) for Lightning Surge Immunity Test

Transient Analysis Of The Active Surge Protection Gap Trigger Process With Lightning Voltage Impulse Injection

An Analysis on Effects of Different Input Phases and Amplitudes on Power Combining

Experimental Study of the Path Characteristics of Partial Discharge Pulses in Generator Stator Windings and in the SSC

Design of Combined Wave Generator by Using Universal Variable Method

Performance Evaluation of Inductive and Capacitive Couplers for Pulsed Current Injection

Resonance at the Front of Lightning Impulse Voltage Waveforms Caused by the Load Capacitor.

Parameter's influence of constraining transient state short current on short circuiting transfer

Analysis of Switching Transient Overvoltage and EMC Design of the ShengGuang-III Power Conditioning System