Numerical simulation investigations into the influence of the mass ratio of pulverized-coal in fuel-rich flow to that in fuel-lean flow on the combustion and NOx generation characteristics of a 600-MW down-fired boiler
Xiaoguang Li,Lingyan Zeng,Hongye Liu,Minhang Song,Wenjie Liu,Hui Han,Shaofeng Zhang,Zhichao Chen,Zhengqi Li
DOI: https://doi.org/10.1007/s11356-020-08275-5
Abstract:Numerical simulations were conducted to study the effects of the pulverized-coal bias distribution in the primary air on the coal combustion and NOx generation characteristics of a 600-MW down-fired boiler with multiple-injection and multiple-staging combustion technology. The total pulverized-coal in the primary air was kept constant, and the ratio of the pulverized-coal mass flux in the fuel-rich coal/air flow to the total pulverized-coal mass flux (RPR) was set as 60%, 70%, 80%, and 90%. By changing the RPR, the excess air coefficient of the fuel-rich flow was adjusted from 0.700 to 0.467. It was found that numerical simulation results were almost in agreement with cold modeling and in situ experimental results respectively, including the flow fields in the lower furnace at the RPR of 80% and the heating processes for the fuel-rich coal/air flow at the RPR of 90%, which verified the rationality of the numerical model and the grid. The simulation results indicated that the change of RPR has little effect on the symmetry of the flow field in the furnace. With the increase of the RPR from 60 to 90%: (1) the maximum airflow declination angle near the tertiary air slot decreased from 71 to 66°, which indicates that the downward airflow penetration depth gradually decreased; (2) the ignition distance of the fuel-rich coal/air flow decreased from 1.2 to 0.9 m, and the high-temperature area in the furnace hopper decreased and the position gradually moved away from the hopper water walls; (3) the oxygen consumption rate at the initial combustion stage constantly accelerated, and the fuel NOx generation rate under the fuel-rich flow nozzle increased first and then decreased; (4) the NOx emissions at the furnace exit dropped from 778 to 662 mg/m3 at 6% O2, and the carbon in the fly ash decreased from 5.87 to 5.52%. Increasing the RPR reasonably controlled the excess air coefficient of the fuel-rich flow, and realized the high-efficiency combustion in the furnace and the reduction of NOx emissions simultaneously.