Abstract:Compliance control is required in the applications of robots for assembling, grinding, polishing and human-robot interface, which needs both position control and force control of robots. The impedance control based on joint torque servo is a promising and practical method to realize compliance control in industrial applications. The performance of a joint torque servo controller is thus crucial to the success of compliance control. However, both nonlinear friction torque of the joint motor and varied dynamics of environmental contact during manipulation increase control difficulty greatly. This paper focuses on the compliance control problem and presents a new joint torque servo controller which is a cascading structure including an inner velocity feedback loop and an outer torque control loop. Due to the high signal-to-noise ratio of the motor velocity, an extended state observer is designed to effectively estimate and compensate for the motor friction torque, varied dynamics of environmental contact and other unknown disturbance. And benefiting from the introduction of the efficient and powerful velocity inner loop, the new torque controller performs very well not only in the rigid but also elastic contact environment. Then a standard PD controller is designed in the outer torque loop to produce the control law. Based on the satisfactory joint torque controller, a simplified impedance control algorithm is designed to achieve the force control. Experiments with three other joint torque controllers on a robot manipulator are conducted to demonstrate the proposed joint torque method and the overall force control framework. These results show the proposed joint torque controller can reduce the steady-state error from 3.07 Nm to 0.21 Nm which indicates the joint actuator friction can be eliminated by more than 99%. And a substantial improvement can also be observed in the experiments of force control based on the new joint torque controller.

Control of Compliant Joint Based on Magneto-rheological Fluid Coupling Transmission.

Modeling and experimental evaluation of vibration reduction of hydraulic-driven joint with a MRF damper

Design Method and Experiment of Robot Joint Flexible Drive Based on Magnetorheological Fluid.

Hybrid fuzzy PID control of hydraulic robot

Design and Analysis of Variable Flexible Actuator for Human-Robot Interaction

Control of a Mechanically Compliant Joint with Proportional-Integral-Retarded (PIR) Controller

An Intelligent Nonlinear Control Method for the Multistage Electromechanical Servo System

Design and control of a compliant robotic actuator with parallel spring-damping transmission

Hierarchical Decoupling Controller with Cylinder Separated Model of Hydraulic Manipulators for Contact Force/Motion Control

Design Validation and Collision Studies of A Compliant Magnetorheological Fluid Actuator

Position Tracking Control of a Magnetorheological Fluid Actuation System

Compliance Control for Robot Manipulation in Contact with a Varied Environment Based on a New Joint Torque Controller

The Compliance Haptic Interface Based on Hybrid Actuating

Residual Vibration Control of a Single-Link Flexible Manipulator with Variable Stiffness and Damping Magnetorheological Joint

Mechatronics Design of a Novel Variable Stiffness Joint Designed with Antagonistic Actuation

Adaptive Impedance Based Force and Position Control for Pneumatic Compliant System

Control of Magneto-Rheological Damper Based on Fuzzy PID Controller

Mathematic Modeling and Optimal Design of a Magneto-Rheological Clutch for the Compliant Actuator in Physical Robot Interactions

A practical PID variable stiffness control and its enhancement for compliant force-tracking interactions with unknown environments

Modelling and Parameter Design of a 3-DOF Compliant Platform Driven by Magnetostrictive Actuators

Optimal Control for a Modified Bouc-Wen Model in a Magnetorheological Fluid Master Robot