Abstract:Environmental pollution by heavy metal ions has received worldwide attention due to their long-term toxicity, non-biodegradability and accumulation in living organisms. Mesoporous calcium-silicate material (MCSM), a cost-effective sorbent synthesized from the desilication liquor of coal fly ash, has been tested its potential for the removal of Cd(II), Cr(III), Ni(II) and Pb(II) from acidic solutions. The effect of initial concentration, m/V ratios, solution pH and ionic strength on the sorption was investigated, and the performance of the material on the removal of heavy metals from simulated wastewater was evaluated. At a m/V ratio of 2g L-1, the maximum sorption capacity of MCSM for metals follows the order: Cd(II)≈Ni(II) (5.52 mmol g-1) > Cr(III) (2.88 mmol g-1) > Pb(II) (2.17 mmol g-1). However, the capacity for Cr(III) significantly decreased with comparatively higher metal concentration due to the strong hydration of Cr(III) which destroyed the crystalline phase of material. The initial concentration had a limited positive effect on the sorption, and the removal efficiency of metals only maintained at a relatively higher level with m/V ratios of up to 2 – 5g L-1. At a low m/V ratio (0.75g L-1), sorption was significantly influenced by solution pH and competition cations under strongly acidic conditions (pHinitial= 2), and the adverse effect disappeared when solution pHinitial ≥3. At an m/V ratio of 5g L-1, the removal efficiency of metals maintained in the range of 96.2 – 100.0% varied with different heavy metal ions. Considerable uptake of Zn(II), Mn(II), Fe(III) and Cu(III) by MCSM was also observed in the simulated wastewater, and the 8 metal ions (each 0.001M) were efficiently removed and the remaining metal concentration < 0.1mg L-1 (except remaining Ni(II) concentration < 1.0mg L-1) at an m/V ratio of 20g L-1. The mechanism responsible for the sorption included surface complexation, ion exchange, and probably precipitation at a high m/V ratio (20g L-1). Ion exchange with Ca(II) in MCSM occurred when m/V ratios ≥ 2g L-1(42.1 – 89.6% for m/V = 2 – 5g L-1), whereas surface complexation would probably occur when m/V ratios less than 1g L-1 due to its structural damage by extensive dissolution to form crosslinked structure which resembles vitreous silica. The results suggest that MCSM has the potential for use as an effective and low-cost sorbent for removing hazardous metal ions from wastewater. Besides, MCSM is suitable for use as a substitute of cement and disposed by inexpensive solidification/stabilization technique after being used as a sorbent. Such a process is helpful for the simultaneous realization of the reutilization of coal fly ash and the removal of toxic metals from wastewater.

Highly efficient capacitive removal of Cd2+ over MoS2-Carbon framework composite material in desulphurisation wastewater from coal-fired power plants

Fast and Effective Removal of Cadmium Ion from Water Using Chitosan Encapsulated Magnetic Fe 3 O 4 Nanoparticles

Insight into the mechanisms of efficient selective removal of Pb 2+ from wastewater by nano-flowered MoS 2 /NHCS electrodes

MnO2 decorated N-doped mesoporous carbon electrodes boost enhanced removal of Cu2+ and Pb2+ ions from wastewater via a hybrid capacitive deionization platform

Chitosan Induced Synthesis of Few-Layer MoS2/Fe-doped Biochar and Its Dual Applications in Cr(VI) Removal

Coal Fly Ash-Derived Mesoporous Calcium-Silicate Material (mcsm) for the Efficient Removal of Cd(Ii), Cr(Iii), Ni(Ii) and Pb(Ii) from Acidic Solutions

MoS2-encapsulated nitrogen-doped carbon bowls for highly efficient and selective removal of copper ions from wastewater

In-situ construction of 3D hierarchical MoS2/CoS2@TiO2 nanotube hybrid electrodes with superior capacitive performance toward water treatment

Tio2 and carbon nanotubes composites modify capacitive deionization anodes to improve the dechlorination efficiency in desulfurization wastewater

Well-dispersed few-layered MoS2 connected with robust 3D conductive architecture for rapid capacitive deionization process and its specific ion selectivity

Metal cobalt dot-doped carbon structures with specific exposure surfaces for high-performance capacitive deionization

Preparation and Evaluation of a Mesoporous Calcium-Silicate Material (MCSM) from Coal Fly Ash for Removal of Co(II) from Wastewater

Simultaneous removal of sulfamethazine and sulfate via electrochemical oxidation and capacitive Deionization: Mechanisms of in-situ activation and strategies of the hybrid system

Manganese silicate/MoS 2 composite material with high adsorption capacity for the selectively removing Cs + from aqueous solution over a wide pH

Capacitive Deionization with MoS2/g-C3N4 Electrodes

Selective electrosorption of heavy metal ions from wastewater with S-doped hierarchical porous carbon derived from waste Camellia oleifera shell

Rationally Designed MoS2 Nanosheet Arrays on Activated Carbon Fibers for Rapid and Selective Lead Removal

Highly efficient capacitive deionization of copper(II) ions from wastewater in symmetric Ti 3 C 2 T x MXene-based electrode: Performance, optimization and deionization mechanism

Biochar derived from coffee grounds with molybdenum disulfide composites for Cr (VI) removal from wastewater

Possibility of Removing Cadmium Pollution from the Environment Using a Newly Synthesized Material Coal Fly Ash

Assessment of electrochemical removal mechanisms of diverse transition metal dichalcogenides for caesium ion removal in wastewater treatment.