Abstract:TiO2 doped with transition‐metal ions is prepared by hydrothermal method. Experimental and theoretical calculations show that due to the uniform distribution of impurity atoms and the addition of oxygen vacancies, the Cr3+/Ov–TiO2 photoanode delivers a greatly increased incident photon‐to‐electron conversion efficiency of 5.4% at 450 nm, superior to the pure TiO2 of 0.03%. Transition‐metal‐ion doping is an effective method to shorten bandgap and enhance visible‐light absorption of TiO2, but there are still some serious challenges for most doping technologies, such as nonuniform doping, severe lattice damages, metal atoms agglomeration, and inactivated impurities. Herein, a simple and universal hydrothermal method is developed to realize the effective transition‐metal ions doping of TiO2 (including Fe, Co, Mn, Cu, V, and Cr). The photoelectrochemical water splitting performances of Cr‐doped TiO2 nanorods with multifarious Cr ion valence states (Cr3+ or Cr6+ ions), various Cr‐ion concentrations, with or without oxygen vacancy activation are emphatically and systematically studied. Experiments and theoretical calculations demonstrate that the remarkably enhanced carrier separation and injection efficiencies are the key factors to improve the visible‐light photoactivity, benefiting from the homogeneous distribution of impurity atoms and the incorporation of oxygen vacancies. The Cr3+‐ion‐doped TiO2 nanorod arrays with oxygen vacancy activation (Cr3+/Ov–TiO2) displays an impressive incident photon‐to‐electron conversion efficiency of 5.4% at 450 nm visible light, far superior to the pure TiO2 of 0.03%. Furthermore, no obvious photocurrent decay is observed in the Cr3+/Ov–TiO2 photoanode after 12 h continuous light illumination.

Transition-Metal-Ion (fe, Co, Cr, Mn, Etc.) Doping of TiO2 Nanotubes: A General Approach.

Facile Fabrication of N-doped TiO2 Nanocatalyst with Superior Performance under Visible Light Irradiation

Transition‐Metal‐Doped TiO2 Nanorods with High‐Visible‐Light Response via a Simple Hydrothermal Method

Preparation of Iron and Chromium Co-Doped TiO2 Nanotubes and Study of Their Photoelectrochemical Properties

Photonic, and Photocatalytic Behavior of Tio2 Mediated by Fe, Co, Ni, N Doping and Co-Doping

Simultaneous Etching and Doping of TiO2 Nanowire Arrays for Enhanced Photoelectrochemical Performance

An Electrochemical Strategy of Doping Fe3+ into TiO2 Nanotube Array Films for Enhancement in Photocatalytic Activity

Invited) Doped Titania Oxide Nanotubes for Photoelectochemical Water Splitting

A facile one-step electrochemical strategy of doping iron, nitrogen, and fluorine into titania nanotube arrays with enhanced visible light photoactivity.

Enhancing visible-light photoelectrochemical water splitting through transition-metal doped TiO2 nanorod arrays

Investigation of Transition Metal Ion Doping Behaviors on TiO2 Nanoparticles

Experimental Studies on TiO2 NT with Metal Dopants through Co-Precipitation, Sol-Gel, Hydrothermal Scheme and Corresponding Computational Molecular Evaluations

Synthesis, Characterization of Cr-doped TiO 2 Nanotubes with High Photocatalytic Activity

Linking the Doping-Induced Trap States to the Concentration of Surface-Reaching Photoexcited Holes in Transition-Metal-Doped TiO2 Nanoparticles

Electrochemical Reduction Induced Self-Doping of Ti3+ for Efficient Water Splitting Performance on Tio2 Based Photoelectrodes

Fabrication and Optical-Electrical Properties of P-Type Manganese-Doped Titanium Dioxide Nano-Films

Facile Preparation Carbon-Doped TiO2 Nanotube Electrodes and Its Enhanced Photoelectrochemical Response

Photoelectrochemical Properties of Metal-Ion-doped TiO2 Nanocrystalline Electrodes

Enhancing Electrochemical Performance of Ultrasmall Fe2O3-embedded Carbon Nanotubes Via Combusting-Induced High-Valence Dopants

A simple electrochemical oxidation method to prepare highly ordered Cr-doped titania nanotube arrays with promoted photoelectrochemical property

Fe3+-Doped Tio2 Nanotube Arrays on Ti-Fe Alloys for Enhanced Photoelectrocatalytic Activity