Abstract:In order to directly observe the conversion between guided-wave modes and leaky-wave modes in a periodic structure, quadrilateral periodic metal diaphragms arranged in two ways on metal surfaces were analyzed. In the first scheme, each unit cell in the periodic structure contains a metal diaphragm, of which the dispersion characteristics of periodic structures were analyzed by the finite element method. The results of the numerical simulation show that by adjusting lattice constants of periodic structures and geometrical parameters of metal diaphragms, the transmission bandwidth of the present 1-D periodic metal diaphragm structures could be limited to X-band, where the transmission characteristics are easy to be measured. In the second scheme, a pair of mirror-symmetric and staggered quadrilateral metal diaphragms is introduced into a unit cell. It can be found in the theoretical calculation that a new dispersion curve, which passes through the light line in a high frequency range, can be exhibited. The propagation constants of dispersion curves become complex numbers and provide highly directional electromagnetic radiation that scans as the frequency changes. After the relative positions of the two metal diaphragms were properly adjusted, the frequency range of the forbidden band gap between two dispersion curves can be minimized, so as to increase the transmission bandwidth of the 1-D periodic metal structures. The experimentally measured results show that the dispersion curves of the two periodic structures were highly consistent with the theoretical results. The narrowing of the band gap could be verified by measuring the $S$ -parameters. The near-field measurement of the periodic metal structures can demonstrate the conversion between the guided-wave modes and the leaky-wave modes, and the far-field measurement can show the frequency dependence of beam elevation. We expect that these artificial material structures could be widely used for designing new microwave and terahertz band devices.

Hybridized plasmonic modes and Fabry-Perot effect in nanoscale bowtie aperture waveguide.

Subwavelength-Confined Hybrid Surface Modes of Low Attenuation in Cylindrical Metallic-Dielectric Waveguides

A Direct Near-Field Observation of Conversion Between Waveguide Modes and Leaky Modes in Periodic Metal Structures

Resonant Effects in Nanoscale Bowtie Apertures

Tunable Propagation Of Light Through A Coupled-Bent Dielectric-Loaded Plasmonic Waveguides

Optical Performance Of Single-Mode Hybrid Dielectric-Loaded Plasmonic Waveguide-Based Components

Characterization of Planar Hybrid Dielectric-Loaded Plasmonic Nano-Waveguides Used for Nano-Photonic Circuits

Microcavity electrodynamics of hybrid surface plasmon polariton modes in high-quality multilayer trench gratings

Bow-Tie Hybrid Plasmonic Waveguides

Spectral resonance of nanoscale bowtie apertures in visible wavelength

Low-loss Hybrid Plasmonic Modes Guided by Metal-Coated Dielectric Wedges for Subwavelength Light Confinement.

Tuning the Resonant Wavelength of A Nanometric Bow-Tie Aperture by Altering the Relative Permittivity of the Dielectric Substrate

Optical resonance of nanometer scale bow-tie antenna and bow-tie shaped aperture antenna

Strong Coupling of Tamm Plasmons and Fabry-Perot Modes in a One-Dimensional Photonic Crystal Heterostructure

Design and Analysis of Bow Tie Aperture with Strong Near-Field Enhancement Effect

Fabrication-Tolerant and Low-Loss Hybrid Plasmonic Slot Waveguide Mode Converter

Movable Fiber-Integrated Hybrid Plasmonic Waveguide on Metal Film

High Transmission Nanoscale Bowtie-Shaped Aperture Probe for Near-Field Optical Imaging

Hybrid wedge plasmon polariton waveguide with good fabrication-error-tolerance for ultra-deep-subwavelength mode confinement.

Hybrid Plasmon Polariton Guiding with Tight Mode Confinement in a V-shaped Metal/dielectric Groove

All-dielectric bowtie waveguide with deep subwavelength mode confinement