Abstract:The ellipticity involved in the Deshpande-Fleck foam model describing the constitutive behaviour of cellular materials was usually considered to be constant, but some very different values were suggested in the literature. A cell-based finite element model of closed-cell foam under uni-/multi-axial compression is employed to verify the Deshpande-Fleck foam model. The ellipticity is determined by applying uniaxial and hydrostatic compression tests and it is found to vary with the equivalent plastic strain, i.e., the ellipticity decreases with the equivalent plastic strain and then increases sustainably before full densification. According to the understandings from the numerical results, a fitting relation between the ellipticity and the equivalent plastic strain is suggested. The ellipticities of an open-cell foam and a closed-cell foam studied experimentally in the literature are fitted well with this relation. A modification to the Deshpande-Fleck foam model with a variable ellipticity is thus proposed. The modified Deshpande-Fleck foam model brings much accurate predictions with using a rigid-plastic hardening (RPH) idealisation model, which describes the stress-strain relation of cellular material under uniaxial compression. Good agreement is also observed between the experimentally measured stress-strain responses and the predictions of the modified Deshpande-Fleck foam model, especially when considering the effect of the plastic Poisson's ratio with a non-associated flow rule. The findings herein are helpful to improve the prediction accuracy of the Deshpande-Fleck foam model.

Revisiting the Deshpande-Fleck Foam Model

Modification and Verification of the Deshpande–Fleck Foam Model: A Variable Ellipticity

A Constitutive Model for Transversely Isotropic Foams, and Its Application to the Indentation of Balsa Wood

Numerical Analysis of Elastoplastic Behavior of Foams with Ellipsoidal Pores

Study on the Yield Behavior of Closed-Cell Foams under Multiaxial Loads Based on Different Yield Definitions

THE MECHANICAL BEHAVIORS OF CLOSED-CELL ALUMINUM-ALLOY FOAMS WITH SPHERICAL PORES

Effect of Imperfections on the Yielding of Two-Dimensional Foams

Computational Plasticity Model for Hydrostatic Pressure Dependent Foam Materials

A Numerical Study on the Large Deformations of Polymer Foams with Spherical Pores

An Analytical Stress-Strain Model for Open-Cell Metal Foam

A new three-dimensional parametric FVDAM for investigating the effective elastic moduli of particle-reinforced composites with interphase

A new modelling method for open cell foam structure based on centroidal and capacity constraint power diagram

A note on the modelling of foams using Voronoi technique

Solving The Elastoplastic Unloading Problems Of An Axisymmetrical Body With Actual Material Hardening Models By Bem

Failure Analysis of Syntactic Foams: A Computational Model with Cohesive Law and XFEM

Three-dimensional modeling of the mechanical property of linearly elastic open cell foams

Modeling Asymmetric Flow of Viscoelastic Fluid in Symmetric Planar Sudden Expansion Geometry Based on User-Defined Function in FLUENT CFD Package

Experimental and Micromechanical Study of Size Effects in the Constrained Deformation of Metallic Foams

Collapse Models of Aluminum Foam Sandwiches under Static Three-Point Bending Based on 3D Geometrical Reconstruction

Predicting the Elastic Properties of Closed-Cell Aluminum Foams: a Mesoscopic Geometric Modeling Approach

An Analytical Modeling for Indentation Response of Sandwich Panels with Gradient Foam Cores