Abstract:In this paper we investigate the dynamics of the inertial sea wave energy converter (ISWEC) device using fully-resolved computational fluid dynamics (CFD) simulations. Originally prototyped by the Polytechnic University of Turin, the device consists of a floating, boat-shaped hull that is slack-moored to the sea bed. Internally, a gyroscopic power take-off (PTO) unit converts the wave-induced pitch motion of the hull into electrical energy. The CFD model is based on the incompressible Navier–Stokes equations and utilizes the fictitious domain Brinkman penalization (FD/BP) technique to couple the device physics and water wave dynamics. A numerical wave tank is used to generate both regular waves based on fifth-order Stokes theory and irregular waves based on the JONSWAP spectrum to emulate realistic sea operating conditions. A Froude scaling analysis is performed to enable two- and three-dimensional simulations for a scaled-down (1:20) ISWEC model. It is demonstrated that the scaled-down 2D model is sufficient to accurately simulate the hull’s pitching motion and to predict the power generation capability of the converter. A systematic parameter study of the ISWEC is conducted, and its optimal performance in terms of power generation is determined based on the hull and gyroscope control parameters. It is demonstrated that the device achieves peak performance when the gyroscope specifications are chosen based on the reactive control theory. It is shown that a proportional control of the PTO control torque is required to generate continuous gyroscopic precession effects, without which the device generates no power. In an inertial reference frame, it is demonstrated that the yaw and pitch torques acting on the hull are of the same order of magnitude, informing future design investigations of the ISWEC technology. Further, an energy transfer pathway from the water waves to the hull, the hull to the gyroscope, and the gyroscope to the PTO unit is analytically described and numerically verified. Additional parametric analysis demonstrates that a hull length to wavelength ratio between one-half and one-third yields high conversion efficiency (ratio of power absorbed by the PTO unit to wave power per unit crest width). Finally, device protection during inclement weather conditions is emulated by gradually reducing the gyroscope flywheel speed to zero, and the resulting dynamics are investigated.

Experimental Study on The Effect of Water Depth and Incident Wave Frequency on The Performance of a OWSC Imposed to Caspian Sea Wave Conditions

Theoretical and Numerical Studies of Off-Shore Oscillating Water Column Wave Energy Device

Research on the Hydraulic Power Take-off Unit of a Hybrid Wave Energy Converter

An experimental evaluation of the effects of sea depth, wave energy converter’s draft and position of centre of gravity on the performance of a point absorber wave energy converter

Numerical Modeling on Hydrodynamic Performance of A Bottom-Hinged Flap Wave Energy Converter

A Flap-Type Seabed-Mounted Wave Energy Converter With Hydraulic PTO: Analytical Investigation & Experimental Analysis

Investigating Wave Energy Potential in Southern Coasts of the Caspian Sea Using Grey Wolf Optimizer Algorithm

Investigation of Sequential Enhancement of Onshore OWC Chamber in a Wave Energy Converter Using Experimental Process

SPH Method with Applications of Oscillating Wave Surge Converter

Experimental Parametric Study on the Primary Efficiency of a Fixed Bottom-Detached Oscillating Water Column Wave Energy Converter in Short-Fetch Sea Conditions

On the performance of an array of floating wave energy converters for different water depths

Fully spectral approach to evaluate the performance of floating wave energy converters in directional complex sea states

Geometric Evaluation of the Hydro-Pneumatic Chamber of an Oscillating Water Column Wave Energy Converter Employing an Axisymmetric Computational Model Submitted to a Realistic Sea State Data

Performance analysis of the combination of a pitching wave surge energy converter and floating breakwaters

Numerical simulation and energy extraction power fitting of OWSCs under regular waves using SPH method

Optimization Study of Hydraulic Power Take-off System for an Ocean Wave Energy Converter

The inertial sea wave energy converter (ISWEC) technology: Device-physics, multiphase modeling and simulations

Experimental study of an onshore dual chamber oscillating water column device

Numerical investigation on the hydrodynamic and conversion performance of a dual cylindrical OWC integrated into a caisson-type breakwater

Effect of wind conditions on the performance of an Oscillating Water Column energy converter

Power capture and power take-off load of a self-balanced dual-flap oscillating surge wave energy converter