Abstract:The adoption of fast-switching silicon carbide (SiC) devices enables power converters to operate at high switching frequencies (e.g., 100 kHz). However, as a limiting factor at high switching frequencies, the dead-time in the conventional pulsewidth modulation (PWM) can cause significant voltage losses, bring serious low-frequency voltage/current harmonics, and reduce the linear modulation region with lower dc-link voltage utilization. Using the dead-time compensation can effectively eliminate the dead-time effect but further reduce the linear modulation region. The dead-time elimination PWM essentially has no dead-time effect. But due to the abandon of drive pulses for generating synchronous rectification, it has a lower converter efficiency, as well as current jumps at zero-crossings. In this article, to overcome the drawbacks of the conventional PWM and the dead-time elimination PWM, a double-modulation-wave PWM for dead-time-effect elimination and synchronous rectification is therefore proposed, where extra drive pulses for generating synchronous rectification are added based on the dead-time elimination PWM. The added drive pulses can also help with mitigating current jumps at zero-crossings. At last, the proposed PWM is experimentally validated and compared with the conventional PWM and the dead-time elimination PWM at 100 kHz on a three-phase converter with SiC mosfets and SiC Schottky diodes, showing the merits of low voltage losses, low output harmonics, high dc-link voltage utilization, large linear modulation region, and high efficiency.

DC-Link Capacitors RMS Current Reduction PWM Method Based High Frequency SiC Three-Phase Inverter

Enhanced Inverter Current Control Method for Variable Frequency Drive System with Small Film DC-Link Capacitor

Operation and Modulation of H7 Current Source Inverter with Hybrid SiC and Si Semiconductor Switches

Review on Pulse-Width Modulation Strategies for Common-Mode Voltage Reduction in Three-Phase Voltage-Source Inverters

Capacitor Voltage Ripple Reduction of A 4-Level Hybrid Clamped Converter Using Switching State Redundancy for Medium-Voltage Drive

A Three-Phase-Module-Parallel Si & SiC Hybrid Inverter with Smaller Filter Size and Low Cost

An Improved PWM Control Method to Reduce Surge Current Through Capacitors in Hybrid-Clamped Multilevel Inverter

An SiC MOSFET & Si Diode Hybrid Three-Phase High-Power Three-level Rectifier

DC-Link Capacitor Current Stress Minimization Strategy for Paralleled Three-Phase Voltage-Source Converters with Interleaving

Analysis and Flexible DV/DT Control of an Active Clamping Topology for Series-Connected SiC MOSFETs

Pwm Control Of A 5-Level Single-Phase Current-Source Inverter With Controlled Intermediate Dc-Link Current

Space Vector Modulation for SiC & Si Hybrid Active Neutral Point Clamped Converter

Capacitors Voltage Ripple Complementary Control on Three-Level Boost Fed Single-Phase VSI With Enhanced Power Decoupling Capability

Voltage Balancing Method for Series-Connected SiC MOSFETs under No Load Condition

A Dc Link Switch-Based Common Mode Voltage Reduction Scheme in Pwm Inverter Drives

A Control Strategy for Reducing Voltage Ripples in Series-Connected SiC MOSFETs Using Active Clamping Modules in High Power VSCs

Space-Vector-Based Hybrid PWM Strategy for Reduced DC-Link Capacitor Current Stress in the Postfault Grid-Connected Three-Phase Rectifier.

A Double-Modulation-Wave PWM for Dead-Time-Effect Elimination and Synchronous Rectification in SiC-Device-Based High-Switching-Frequency Converters

Minimization of DC-Link Ripple Current for Enhancing Reliability in Three-Level Voltage Source Inverters

Control Method of PMSM Driving System with Small DC-Link Capacitor

A Three-Phase Si & SiC Hybrid Three-Level Hybrid Legs (hybrid2) Inverter with Optimal Power Quality and Low Cost