Abstract:This paper analyzes the microstructure and electrical insulation characteristics at the interface of 500 kV cross-linked polyethylene (XLPE) cable factory joints for extra high voltage direct current (EHVDC) application. The interface between two layers was polished by different grit sandpapers (80, 400, 1000, 2000, and 0000 (unpolished)). The samples (#1000) polished by 1000 grit mesh at the interface were degassed at 70 degrees C for 0, 12, 36, 90, and 200 h, respectively. Physico-chemical and electrical experiments were performed on the prepared test samples. It is found that increasing the number of sandpaper grit meshes reduces the average lamellae thickness at the interface and increases the crystallinity. Moreover, microporous defects are observed at the interface. The parameters viz elongation at break, current density, and the number of microporous defects increase initially and then decrease. However, the space charge accumulation, threshold electric field strength, and DC breakdown decrease initially and then increase. Notably, the #1000 roughness is a turning point. On the other side, degassing treatment promotes the orderly folding and recrystallization of the molecular chains arranged the amorphous region and significantly reduces the microporous defects at the interface. The mechanical properties are affected to a certain extent. The improved microstructure reduces the space charge accumulation and the current density of the sample, and increases the DC breakdown strength. An interfacial microscopic model and a charge transport model are proposed to analyze the mechanism of material properties under different roughnesses and electric fields. The results indicate that the ultra-smooth interface and degassing treatment strengthen the molecular chain linking at the interface. Moreover, they significantly reduce the microporous defects at the interface and improve the insulation properties of the factory joint. (C) 2021 Elsevier Ltd. All rights reserved.

Study on Ablation Between Metal Sheath and Buffer Layer of High Voltage XLPE Insulated Power Cable

Study on the Ablation Process and Failure Mechanism of the Buffer Layer in High-Voltage XLPE Cable

The Evaluation of the Buffer Layer Chemical Corrosion for HV XLPE Insulated Cable with Corrugated Aluminium Sheath Structure

Research on Compensation and Protection of Voltage in Metal Shield of 110kv Power Cable under Three Segments Unsymmetrical State

Analysis on Buffer Layer Discharges below the Corrugated Aluminum Sheath of XLPE Cables and Comparison with Other Metal Sheath Structures

Study on the Current Concentration and Local Heating of the Buffer Layer in HV XLPE Cables

Cause Analysis of Aging Ablation on Sheath of 110 Kv Single Core High Voltage Cable

Study on Multi-Parameter Detection Methods of Buffer Layer Ablation for 110kv Cable

Investigation on Thermal Aging and Degradation of XLPE for High Voltage Cable Applications

Multi-Physical Signal of True Cable Buffer Layer Ablation

The Formation Mechanism of White Substances on Water-blocking Buffer Layer of HV XLPE Cables

Interfacial Microstructure and Insulation Properties of 500 Kv EHVDC XLPE Cable Factory Joint under Different Roughness and Degassing Durations

Effects of the Inhomogeneous Microstructures on Buffer Layer Ablation Failure in High Voltage Cables

Experiments on the ultrasonic detection of buffer layer ablation defects in high-voltage cables

Multi-Physical Quantity Detection of Buffer Layer Ablation under Air Gap Discharge Condition

AC corrosion analysis of the buffer layer in HV corrugated-aluminum sheathed power cables

Design of Smooth Aluminum Bonded Sheaths in HV XLPE Cables Based on the Bending Performance Research

Revitalising high voltage cable: Exploring effective repair methods and influential factors for buffer layer defects using conductive silicone rubber

Key Process of the Defection of PET Buffer Layer in XLPE Power Cable by a Case Study: Thermo-oxidative Degradation

Multi-Parameter Detection of Defects in HV Cable Buffer Layer Based on Gas, Temperature, and Pressure

Dynamic Conductive Property and Mechanism of Buffer Tape in HV XLPE Cables