Abstract:Performance of a conventional phase detector implemented using analog circuitry is affected by, among other factors, the parameter value drifting of the analog components with environment (e.g., temperature) and time (i.e., aging). It is also adversely impacted by electromagnetic interferences likely existing in the analog circuits when the detector operates in a high frequency range. More importantly, such a detector is inflexible to compensate various nonlinear characteristics of sensors and is very difficult to realize sophisticated signal processing strategies desired for practical applications. To address issues like these, we have developed a digital system approach that uses the zero-crossing algorithm for phase detection. The phase detection limit and dynamic phase response of the system were assessed using surface acoustic wave (SAW) sensors. Our preliminary evaluation involved AlN dual-mode differential sensors, which were fabricated on an AlN(0001)/Al2O3(11 2 ¯ 0) thin film structure, with the SAW and shear horizontal SAW (SH-SAW) operating at approximately 243 MHz and 256 MHz, respectively. Due to the hardware constraints, the digital phase processing was carried out in an off-line fashion. Our baseline experiments without sensor indicate that the system can achieve a lower level of phase noise with the standard deviation being about 0.005°. Experiments with the differential sensors running in the SAW and SH-SAW modes exhibit that the system can reach a phase detection limit of 0.02°. The differential system showed small temperature coefficient at ppm level measured by varying the sensor temperature using a thermal control oven. Finally, our use of the system in measuring the response of the SH-SAW sensor to sodium chloride (NaCl) solution conductivity shows that the system is capable of performing microanalysis of liquid properties. We conclude that a real-time fully digital phase detection system can be practically achieved.

A Differential Detection Method Based on a Linear Weak Measurement System.

A differential weak measurement system based on Sagnac interferometer for self-referencing biomolecule detection

A lateral differential confocal microscopy for accurate detection and localization of edge contours

A Bio-molecular Sensor Based on Optical Weak Measurement

Differential Microwave Microfluidic Sensor Based on Microstrip Complementary Split-Ring Resonator (MCSRR) Structure

Optical Weak Measurement System with Common Path Implementation for Label-Free Biomolecule Sensing.

A Symmetrical Optical Waveguide Based Surface Plasmon Resonance Biosensing System

Detection of Macromolecular Content in a Mixed Solution of Protein Macromolecules and Small Molecules Using a Weak Measurement Linear Differential System.

Differential internal multi-reflection method for nano-displacement measurement

Difference Weak Measurement

Study and Numerical Simulation of a Surface Plasmon Resonance Sensor Using Bi-Beam Differential Measurement Approach

A Novel Direct-Conversion Structure For Non-Contact Vital Sign Detection System

A Novel Raman Spectrum Detection System Based on an Integrated Optical Biosensor

Spectrum Intensity Ratio Detection for Frequency Domain Weak Measurement System

A Self-Reference Interference Sensor Based on Coherence Multiplexing

Virtual instrumentation based automatic thin film resistivity measurement system

Ultrasensitive Total Internal Reflection Sensor with Rotatory Biased Weak Measurement

Demonstration of a New Characterization Method for Weak Measurement

Ultrasensitive biased weak measurement for longitudinal phase estimation

An Integrative Biosensor Based on Contra-Directional Coupling Two-dimensional Photonic Crystal Waveguides

Digital phase detection approach and its application for AlN dual-mode differential surface acoustic wave sensing