Abstract:The single pole-to-ground (SPG) fault is one of critical failures which will have a serious impact on the stable operation of the multi-terminal DC distribution network based on the modular multilevel converter (MMC). It is very significant to analyze fault characteristics for detecting faults and protection design. This paper established the DC SPG fault model, which showed that in the presence of a reactor, the short-circuit current was reduced from 2.3 kA to 1 kA at 6 ms after the fault. Then, a novel SPG fault protection strategy was proposed, which detected the current derivative in connection transformer grounding branch. When the value increases past the threshold of current derivative, small resistance was switched on to increase fault current. Thus, the reliability of differential protection was enhanced. Compared with the traditional protection method, the proposed method does not need communication, and improved the speed of protection. Finally, the simulation model was established in PSCAD/EMTDC. The model included three converter stations: T1, T2 and T3. Among them, T1 outputs power, and T2 and T3 receive power. The results of RTDS showed that the DC circuit breaker operated within 3 ms, the three-port circuit breaker worked within 50 ms, which proves that the proposed strategy was effective. At this time, the system switched from the T1–T2–T3 three-terminal networking operation mode to the T1–T2 two-terminal hand-in-hand operation mode. Since the T3 terminal no longer received power, the transmission power of the T1 terminal decreased, and the received power of the T2 terminal remained unchanged.

Research on DC Distribution Network Protection Technology

Research on a Line Protection Method for DC Distribution System Based on Parameter Identification

Review on DC Distribution Network Protection Technology with Distributed Power Supply

Modeling And Simulation Of Dc Distribution Network Based On Distributed Energy

Review on Network Topology and Fault Diagnosis Technology of DC Distribution Network

Protection Schemes for Distribution Lines in DC Power Grid

GOOSE Network Faults Analysis and Treatment of Data Substation

Research status and prospect of control and protection technology for DC distribution network

Application of IEC 61850 GOOSE Technology on Protective Relaying

Topology of Current-Limiting and Energy-Transferring DC Circuit Breaker for DC Distribution Networks

A Review of the Protection Methods in DC Distribution System

A Protection Method for DC Distribution Network Based on High and Low Frequency Current Amplitude Ratio

A Novel Protection Strategy for Single Pole-to-Ground Fault in Multi-Terminal DC Distribution Network

Network Structures and Key Technologies of DC Distribution Systems

Development of a New Type of Leakage Current Protection Device for Distribution Network

A Novel Protection Scheme for DC Distribution Network with Multi-terminal PV

A Protection Scheme of Ac Side Faults of Dc Distribution System

Research on Staged Relay Protection of DC Distribution System

Protection Method and Coordination with Dc Circuit Breaker in DC Distribution Power Grid

Study on Goose-based 10 Kv Bus Protection in Substation

Studies of fault protection strategies aiming to DC system with DC converter