Abstract:Lead-acid batteries need to evolve to keep up with the electrification of vehicles and not lose ground to other technologies. The grid designed using a lead alloy thus plays a very important role in the performance of the battery, as, in the course of the various cycles, this component undergoes a natural corrosion process at positive potential, while immersed in a sulfuric acid solution. The aim of this study is therefore to examine the effect of the addition of calcium and bismuth on the microstructure, mechanical behavior and corrosion resistance of the Pb1.5%Sn alloy, with a view to using this in the positive grid of lead-acid batteries. The alloys developed during this study were evaluated using optical microscopy and scanning electron microscopy. Mechanical properties were investigated using universal tensile and hardness tests. Electrochemical tests of cyclic voltammetry, chronoamperometry and electrochemical impedance spectroscopy were carried out in a 5M sulfuric acid solution at 25 °C to simulate the behavior of the alloy when in operation. The composition of the corrosion products formed were subsequently characterized by morphological analysis using scanning electron microscopy and the composition was determined using energy dispersive X-ray spectroscopy and X-ray diffraction analysis. The results indicate that the Pb1.5Sn0.12Bi alloy presented better corrosion resistance characteristics than the Pb1.5Sn0.05Ca alloy, making it suitable for inclusion in the composition of the positive electrode of a lead-acid battery. Further investment is however required to compensate for the shortcomings in relation to the mechanical properties of the material.

Evaluation of the effect of additive group five elements on the properties of Pb-Ca-Sn-Al alloy as the positive grid for lead-acid batteries

The Influences of Silver and Zinc Addition on the Electrochemical Performances of the Pb–Ca–Sn Grids for Lead Acid Batteries

The effect of Ca and Bi addition on the mechanical strength, corrosion resistance, and Rechargeability of Pb1.5Sn alloy for the positive grid of lead-acid batteries

Properties and Application of Pb-Ca-Sn-Al-Ag-La-Ce Alloys for Positive Grids of Electric Vehicle Batteries

Effect of lanthanum, cerium and other elements on the electrochemical corrosion properties of Pb–Ca–Sn–Al alloy in lead–acid batteries

Research on Thin Grid Materials of Lead-Acid Batteries

Recent Development of Lead-Acid Battery Grid Materials

The anodic films on lead alloys containing rare-earth elements as positive grids in lead acid battery

Construction of conductive oxide layer on the surface of lead alloy grid for the long life of lead acid batteries

Anodic Behavior of Lead Alloy with Rare Earth Additive in Sulfuric Acid Solution

Study of electrochemically active carbon, Ga2O3 and Bi2O3 as negative additives for valve-regulated lead-acid batteries working under high-rate, partial-state-of-charge conditions

A Review of the Positive Electrode Additives in Lead-Acid Batteries

PROPERTIES OF ANODIC SCALE OF NEW Pb- Ca GRID ALLOY

The Effect of Cerium on the Anodic Behavior of Pb-Ca-Sn Alloy in Sulfuric Acid Solution

Effects of additives on the discharge behaviour of positive electrodes in lead/acid batteries

Effect of Sm Addition on the Electrochemical Behavior and Discharge Performance of Mg-1Sn-1Ca-0.3Mn Alloy as Mg-Air Battery Anodes

The critical role of boric acid as electrolyte additive on the electrochemical performance of lead-acid battery

Investigation on the Mechanical and Chemical Properties of Novel Pb-Sb Grid Alloys with RE Additive

Effect of Cerium on Gas Evolution Behavior of Pb-Ca-Sn Alloy

Improving Corrosion Resistance of Lead-Alloy Positive Grid of Lead-Acid Battery by an Electrochemical Prepassivation Interphase

Strategic Alloy Design for Liquid Metal Batteries Achieving High Performance and Economic Stability