Abstract:This paper proposes a new type of fabricated shear wall system, that is, the two ends of the horizontally distributed ribs and the top of the vertical distributed ribs are reliably connected with the cast-in-situ belt, and the bottom of the vertical distributed ribs is not penetrated and only connected by mortar. To study the seismic performance of the new wall, 7 specimens of the shear wall were designed and manufactured, including 2 cast-in-place shear walls and 5 new fabricated shear walls. Through low-cycle reciprocating loading tests, different analyses were made. Shear span ratio and different edge restraint structure of the new fabricated shear wall failure mode, bearing capacity and other seismic performance, and through OpenSees finite element analysis of the wall to verify the correctness of the modelling method. The test results show that the failure characteristics of the new wall are mainly the cracking and penetration of the mortar layer, the crushing of the corner concrete and the local buckling of the steel bars at the bottom of the edge members; compared with the cast-in-place wall, the new wall has the lower bearing capacity, but the deformation and energy consumption are not much different. The reinforced edge members can effectively compensate for the weakening of the integrity of the wall panel caused by the discontinuity of vertical steel bars. Among the 7 specimens, the overall performance of the wall with increased longitudinal reinforcement ratio is the best. The error between the wall finite element results and the test results is less than 5%, which shows that the modelling method in this paper has sufficient accuracy for the evaluation of the seismic performance of the new wall. In general, the new prefabricated shear wall system is feasible in high-rise buildings.

Seismic Reliability Evaluation of Steel-Timber Hybrid Shear Wall Systems

A SIMPLIFIED ANALYTICAL PROCEDURE FOR SEISMIC ANALYSIS OF TIMBER LIGHT-FRAME SHEAR WALLS

Seismic Behavior of Composite Shear Walls Incorporating Concrete-Filled Steel and FRP Tubes As Boundary Elements

Seismic performance assessment of steel frame infilled with prefabricated wood shear walls

Seismic Reliability Analysis of Diagonal-Braced and Structural-Panel-Sheathed Wood Shear Walls

Self-Centering Steel-Timber Hybrid Shear Wall: Experimental Test and Parametric Analysis

Study on the Seismic Performance of Frame-shear Wall Structures with High-strength Reinforced the Shear Wall

Seismic performance of Chinese traditional timber frames

Quasi-static tests and parametric simulations of hybrid steel frame and light wood shear walls with frictional dampers

Seismic performance assessment of new dry‐assembled prefabricated composite shear wall system with beam‐only connection

Numerical Analysis Study on Seismic Performance of Semi-Rigid Steel Frame Infilled with Prefabricated Composite Wall Panels

Experimental and Numerical Investigation on Seismic Performance of a Hybrid RC Frame System with Stiffened Masonry Wall

Seismic behavior of innovative hybrid CLT-steel shear wall for mid-rise buildings

Seismic behavior of prefabricated concrete filled steel tube-bordered monolayer reinforced shear wall

Experimental and analytical fragility assessment of a combined heavy timber–steel‐braced frame through hybrid simulation

Experimental Study on the Seismic Behavior of a Frame-Supported Reinforced Masonry Short-Limb Shear Wall Structure

Seismic performance of light wood shear wall infilled timber frame structures with openings

Seismic Analysis and Design of Composite Shear Wall with Stiffened Steel Plate and Infilled Concrete

Experimental study on seismic performance of new-type fabricated shear wall with mortar connection

Seismic behaviors of steel plate shear wall structures with construction details and materials

Seismic behavior of composite shear walls incorporating high-strength materials and CFST boundary elements