Abstract:The development of a realistic numerical model that predicts the impact behavior of adhesively bonded composite joints is important for many industrial sectors such as automotive, aerospace, and marine. In this study, it was aimed to develop a numerical model that can predict the low-velocity oblique impact behavior of composite single-lap joints close to the experimental results. The validation of the proposed numerical model was carried out with the results of the previously experimentally tested joints. In explicit finite element analysis, the orthotropic material model and Hashin's damage criterion were used in the numerical model of composite adherends. The adhesive region was divided into three different regions. The cohesive zone model (CZM) was used to determine the damage initiation and propagation in the upper and lower interface regions of adhesive. The middle region of the adhesive between the two cohesive interfaces was modeled with an elastic–plastic material model to reflect the plastic material behavior of the adhesive in the analysis. The effects of impact angle, fiber orientation, and overlap length on adhesive damage initiation and propagation were investigated in detail. There is a good agreement between the numerical and experimental results, considering the contact force-time variations and composite and adhesive damage. The impact angle and fiber angle had a significant effect on the impact behavior of the composite joints and the adhesive damage initiation and propagation. The increase in impact angle and fiber angle caused a decrease in the maximum contact force value. Adhesive damage propagation patterns varied according to the composite fiber orientation. In addition, since the shear toughness of the adhesive is higher than its tensile toughness, the amount of adhesive damage and damage propagation rate decreased as the impact angle increased.

Investigations on Low-Energy Impact and Post-Impact Fatigue of Adhesively Bonded Single-Lap Joints Using Composites Substrates

Effects of low-energy impact at different temperatures on residual properties of adhesively bonded single-lap joints with composites substrates

Experimental study on dynamic behavior of CFRP-to-steel interface

Research on the Aging Effects of Adhesive and Composites on the Degradation Mechanism of Composite Adhesive Joints in Thermal-Humidity-Cycles for Automobiles

Experimental and Numerical Study of Low-Velocity Impact and Tensile after Impact for CFRP Laminates Single-Lap Joints Adhesively Bonded Structure

Effects of impact fatigue on residual static strength of adhesively bonded joints

Finite Element Analysis of Low-Speed Oblique Impact Behavior of Adhesively Bonded Composite Single-Lap Joints

A Study of the Effects of Moisture on Composite-to-Metal Double-Lap Shear Joints

Material and adhesive effect in adhesively-bonded composite stepped-lap joints

Investigation of Residual Strength in CFRP Double-Adhesive Single Lap Bonded Joints after Low-velocity Impact

Enhancing Fatigue Life and Strength of Adhesively Bonded Composite Joints: A Comprehensive Review

Experimental study of the influence of adhesive reinforcement in lap joints for composite structures subjected to mechanical loads

Fatigue and Tensile Behaviors of High Stiffness Adhesive Bonded and Hybrid Joints with Composite-Steel Dissimilar Materials

The structural response of the thermoplastic composite joint subjected to out-of-plane loading

EXPERIMENTAL INVESTIGATION ON ADHESIVE BONDED JOINTS OF CARBON FIBER COMPOSITE LAMINATES CONTAINING DISBOND DEFECT

Evaluation of Fatigue Damage Monitoring of Single-Lap Composite Adhesive Joint Using Conductivity

Investigation on shear and fatigue performance of CFRP/aluminum alloy single-lap adhesive joint

A unified strain energy-based fatigue life prediction methodology for composite and metal adhesive joints: Effects of adhesive, geometry and, environment

Effect of Adhesive Layer Thickness on Strength of Carbon-Fiber-Reinforced Plastic/Aluminum Bond-Riveted Joints

Experimental investigations of bolted, adhesively bonded and hybrid bolted/bonded single-lap joints in composite laminates

Fatigue characteristics of sandwich composite joints in ships