Abstract:Polyethylene (PE) pipe, particularly high-density polyethylene (HDPE) pipe, has been successfully utilized to transport cooling water for both non-safety-related applications and safety-related applications in nuclear power plant (NPP). However, concerns of a lack of non-destructive examination (NDE) procedures and qualifications specialized for HDPE pipe impede its broader application. Traditional approximation without considering effects of acoustic dispersion could work for PE pipe with a small inspection depth. But for PE pipe of large size used in nuclear power plant, effects of acoustic attenuation and dispersion accumulate with depth, and have influence on waveforms of target pules, which brings great challenges to the energy concentration when performing ultrasonic phased-array inspection for PE pipe in NPP. In this paper, a theoretical method applying Szabo's causal convolutional propagation operator based on causality theory was presented to obtain wave equations of ultrasound in PE considering both attenuation and dispersion, in which attenuation coefficient and phase velocity were used to separately characterize acoustic attenuation and dispersion. Then, an experimental method using ultrasonic spectroscopy technology was proposed to confirm the proposed model, and a good agreement was obtained. The results indicated that attenuation coefficient of PE had an approximately linear relation with frequency and that phase velocity rose logarithmically with frequency. Finally, effects of attenuation and dispersion on amplitude spectrum and waveform in time domain of the target signal were investigated. Frequency downshift and time delay shift had an influence on image resolution and focus capability, and were believed to be a restriction of current inspection technology. This work also theoretically proved that lower testing frequencies (less than 2.5MHz) could improve the inspection effectiveness of the applied inspecting systems for HDPE pipes in NPP applications.

An Improved Phased Array Ultrasonic Testing Technique for Thick-Wall Polyethylene Pipe Used in Nuclear Power Plant

Research on Phased Array Ultrasonic Technique for Testing Butt Fusion Joint in Polyethylene Pipe

Study on Industrial Computed Tomography Detection and Identification of Inclusion Defects in Thick-Wall Polyethylene Pipe Butt Fusion Joint Within Nuclear Power Plant

Phased Array Ultrasonic Technology Optimization for Electro-Fusion Joint of Polyethylene Pipe

Simulation of PA-UT Sector Scanning Imaging of Irregular Defects in Polyethylene Pipe Based on Finite Element Analysis

Investigation On Acoustic Propagation Of Ultrasound In Polyethylene Pipe Used In Nuclear Power Plant

Experimental and Numerical Investigation on the Seismic Behavior of above Ground High Density Polyethylene Pipe in Nuclear Power Plant

Evaluation of Pipe Axial Defeat Through the Use of Ultrasonic Guided Wave and Matching Pursuit

Ultrasonic Inspection of Electrofusion Joints of Large Polyethylene Pipes in Nuclear Power Plants

RECONSTRUCTION OF PHASED ARRAY ULTRASONIC TESTING IMAGE OF THROUGH HOLE BASED ON FINITE ELEMENT ANALYSIS

The Research on Automatic Defect Recognition for Phased Array Ultrasonic Inspection of Polyolefin Butt Thermal-Fusion Joint

Ultrasonic Inspection of Large Diameter Polyethylene Pipe Used in Nuclear Power Plant

Ultrasonic Technique For Testing Cold Welding Of Butt-Fusion Joints In Polyethylene Pipe

Application of Ultrasonic Guided Waves for Inspection of High Density Polyethylene Pipe Systems

Ultrasonic array imaging of highly attenuative materials with spatio-temporal singular value decomposition

Ultrasonic phased array detection method for butt fusion welding defects of HDPE pipes

Study on Ultrasonic Testing of Electro-Fusion Joint of Polyethylene Pipe

A Review of Nondestructive Examination Technology for Polyethylene Pipe in Nuclear Power Plant

Effect of the ultrasonic phased array on defect detection of HDPE electro-fusion joint

A Method of Ultrasonic Phased Array Inspection of Middle-High Pressure Plastic Pipe Reinforced by Cross Helically Wound Steel Wires Electro-Fusion Joint

Phased Array Ultrasonic Testing on Thick Glass Fiber Reinforced Thermoplastic Composite Pipe Implementing the Classical Time-Corrected Gain Method