Abstract:Solar Salt, a molten nitrate salt, plays a crucial role in heat transfer and storage within solar thermal power plants. It helps to mitigate power output fluctuations resulting from changes in sunlight. Additionally, it allows nuclear power plants with thermal energy storage adjusting power output to better meet grid demand, all without altering reactor power. Maintaining the stability of Solar Salt is vital for ensuring the efficiency and cost-effectiveness of these operations. A study was conducted by subjecting fresh Solar Salt to pre-heating at temperatures surpassing the typical operational limits, referred to as the precondition phase, of the Natrium™ Demonstration nuclear plant being built with TerraPower, LLC and GE-Hitachi technology. Subsequently, the focus centered on examining the thermal stability of the preconditioned molten salt under the maximum operating conditions within the ambient atmospheric environment. The preconditioned molten salt, kept at 540 °C for 10 days, consistently exhibited minimal daily mass loss rates at its maximum operating temperatures of 480 and 510 °C, in contrast to the unpreconditioned salt, where initial daily rates were higher and then gradually decreased over time. Furthermore, the molar ratios of nitrite to nitrate ions in the preconditioned salt melts decreased and eventually stabilized at equilibrium states under these maximum operating temperatures. The equilibrium concentrations in the preconditioned melts approached those of the unpreconditioned melts, where nitrite/nitrate ratios increased and eventually stabilized. During the decomposition of both preconditioned and unpreconditioned melts, oxide formation gradually increased but did not reach an equilibrium state. However, the preconditioned melts exhibited lower rate constants at temperatures of 480 °C and 510 °C over time. The onset of melting temperature, initially recorded at 211 °C for the preconditioned 480 and 510 °C melts, gradually increased as the nitrite/nitrate ratios decreased over time, ultimately achieving stability. In contrast, the unpreconditioned 480 and 510 °C melts experienced a gradual decline from 221 °C in their melting points until they reached equilibrium. In , the preliminary treatment of Solar Salt at temperatures exceeding the maximum operation temperatures serves to eliminate impurities and enhance the stability of the molten salt. This preparatory step is essential when using molten nitrate salt as a medium for transferring thermal energy from the sodium cooling loops to the steam generation process in nuclear power plants with thermal energy storage.

Probing Thermal Decomposition Mechanism of Molten Nitrite/nitrates Salt by Time of Flight Mass Spectrometry

Heterogeneous 3D Morphological Evolution of Ni Microparticles in Molten Salts: Visualized by Operando Synchrotron X-ray Nano-tomography

The Non-isothermal Kinetic Analysis of Thermal Decomposition of Mg(OH)2

Thermal stability of sodium nitrate–sodium nitrite melts: A Raman spectra study

Study on 5-Nitro-2,4-dihydro-3h-1,2,4-triazol-3-one (NTO) Decomposition Using Online Photoionization Mass Spectrometry and Theoretical Simulations

Effect of pre-heating on thermal stability of molten nitrate salt

Angeli's Salt (na2n2o3) is a Precursor of HNO and NO: a Voltammetric Study of the Reactive Intermediates Released by Angeli's Salt Decomposition

Thermal Decomposition Mechanism of Nitroglycerin by ReaxFF Reactive Molecular Dynamics Simulations

Thermal Decomposition Paths of Calcium Nitrate Tetrahydrate and Calcium Nitrite

Investigating the impact of two representative nitro explosives on the thermal decomposition mechanism of DNTF through ab initio molecular dynamics

The deoxygenation mechanism of biomass thermal conversion with molten salts: Experimental and theoretical analysis

Investigation of the decomposition mechanism of MTNP melt-cast explosive at different temperatures and pressures through ReaxFF/lg molecular dynamics simulations

Influence of atmosphere and austenitic stainless steel on the solar salt corrosivity

Experimental Study on Molten Salt Oxidation of High Salt Content Pharmaceutical Residue

Insight into thermal decomposition behavior of ammonium dinitramide‐based liquid propellant through reactive molecular dynamics simulations

Experimental and Numerical Simulation Study on Thermal Decomposition Model of Ammonium Nitrate

Isotope Tracing Experiment on the Mechanism of O2 on the Over-Thermal Decomposition of SF6

Simultaneous Gas-phase Detection of Nitric Oxide (NO) and Nitrous Oxide (N2O) from the Decomposition of Angeli's Salt (Na2N2O3) at Different pHs Using Tunable-diode Laser Absorption Spectroscopy

Investigating the decomposition mechanism of CL-20/MTNI cocrystal explosive under high temperature and high pressure using ReaxFF/lg molecular dynamics simulations

Mechanisms of HNO and NO Production from Angeli's Salt: Density Functional and CBS-QB3 Theory Predictions

Chemistry of N2O Decomposition on Active Sites with Different Nature: Effect of High-Temperature Treatment of Fe/ZSM-5