A Novel Approach to the Fabrication of Lamellar Al2O3/6061Al Composites with High-Volume Fractions of Hard Phases

Yun-Liang Li,Ping Shen,Li -Kai Yang,Xun Sun,Qi-Chuan Jiang

DOI: https://doi.org/10.1016/j.msea.2019.03.065

2019-01-01

Abstract:Freeze casting has been widely used in the preparation of nacre-inspired composites because of its prominent advantages in controlling the fine structure of ceramic scaffolds. However, the ceramic-phase content in composites prepared by this method is much lower than that in nacre due to the limitations of the dispersion and viscosity of the ceramic slurry. In this work, we combined the ideas of freeze casting and in-situ reaction to prepare nacre-inspired lamellar composites with high hard-phase contents. We first prepared the TiO2- - SiO2 porous scaffold with an initial solid loading of 20 vol% via unidirectional freeze casting and then infiltrated it with a 6061Al alloy. During the reaction process, the TiO2-SiO2 layers were progressively transformed into Al2O3 layers, and the Al layers were transformed into Al3Ti. Composites with different hard-phase volume fractions (approx. 29%, 38%, 52% and 65%) and different interfacial bonding strengths could be obtained by altering the infiltration temperature. Increases in the hard-phase content and the interfacial bonding strength substantially enhanced the bending and compressive strengths of the composites, with maximum values of 350 MPa and 854 MPa, respectively, achieved in the composites with approx. 65 vol% hard phases. However, the highest fracture toughness of 42.9 MPa m(1/2) and maximum fracture work of 3.6 kJ/m(2) appeared when the hard-phase content in the composite was approx. 38 vol%, sharing an appropriate interfacial bonding strength. A robust interface favors stress transfer but impedes crack deflection, while a weak interface fails to bear loads, even though it is conducive to crack deflection. A moderately-strong interface together with a considerable amount of layered soft phase contributes to the generation of multiple-cracking, and thereby greatly toughens the metal - ceramic composite.