Abstract:Abstract Much work has been done on hydraulic-fracturing as a well stimulation technique but our understanding of formation damage due to fracturing is limited. This is due to inherent complexity of shale-water interactions under subsurface conditions. Damage is triggered by cold and low-salinity water invasion into the formation. Here, we introduce the formation damage mechanisms as a multi-physics/chemistry problem developing in a region near the fracture-matrix interface. Using high-resolution flow simulation models, we investigate the mechanisms and their impact on natural gas production. The simulation model includes geo-mechanically fully coupled non-isothermal multi-component two-phase flow equations that are developed for a multi-scale porous medium representative of the shale formations. We consider the occurrence of formation damage during two consecutive periods: well shut-in period which is considered to begin with the completion of fracturing and extending 1-2 days; followed by water flow-back and gas production period which takes months. During the early shut-in period, cold water invasion leads to thermal contraction of the matrix and reduces the normal mean stress. These changes improve the formation permeability temporarily, they may create secondary fractures, and modify the capillary pressure and saturations in the water invaded zone. These thermal effects are reduced rapidly, however, due to heat supplied by the reservoir. Osmosis pressure and the associated clay swelling cause the formation matrix to absorb fracturing water, reduce the matrix permeability, and amplify the capillary pressure/saturations. In summary, the well goes to the flowback and production with modified near-fracture conditions. During the water flowback the water saturation near the fracture-matrix interface increases; hence, liquid blockage effect on the gas flow becomes larger than that predicted based on the water imbibition during the shut-in only. This is due to capillary-end-effect developing near the interface during the water flow-back, when the fracturing water is displaced by the gas, i.e., drainage. Clay swelling and stress change continue during the withdrawal of the fluids. Consequently, we observe significant impairment in gas production rates. Only a fraction (<20%) of the injected water is ultimately produced back from the shale gas wells; the rest stays in the fractures and invades into the formation. Our simulation work shows that it is mainly the water in the fractures that are produced. The rest stays in the fractures due to relative permeability effects therein, and in the matrix as capillary-bound water due capillary end effect and to clay-swelling.

The Damage Mechanisms of Fracturing Fluid on Production in Tight Gas Reservoirs

Influence of reservoir physical properties on guar gum fracturing fluid damage in unconventional tight reservoirs

Study of Fracturing Fluid on Gel Breaking Performance and Damage to fracture conductivity

Experimental investigation on the high-pressure sand suspension and adsorption capacity of guar gum fracturing fluid in low-permeability shale reservoirs: factor analysis and mechanism disclosure

Investigation on the microscopic damage mechanism of fracturing fluids to low-permeability sandstone oil reservoir by nuclear magnetic resonance

Investigation on microscopic invasion characteristics and retention mechanism of fracturing fluid in fractured porous media

Study on the Imbibition Damage Mechanisms of Fracturing Fluid for the Whole Fracturing Process in a Tight Sandstone Gas Reservoir

Experimental study on the adverse effect of gel fracturing fluid on gas sorption behavior for Illinois coal

Experimental quantification of formation damage caused by the cross-linked gel in tight gas reservoirs

Study on Matrix Damage and Control Methods of Fracturing Fluid on Tight Sandstone Gas Reservoirs

Design of facile technology for the efficient removal of hydroxypropyl guar gum from fracturing fluid

Formation Damage Mechanisms Due to Hydraulic Fracturing of Shale Gas Wells

Pore structure characterization and its influence on aqueous phase trapping damage in tight gas sandstone reservoirs

Investigation of the Effect of Fracturing Fluids on Shale Pore Structure by Nuclear Magnetic Resonance

Numerical analysis of the production behaviors and geomechanical responses during natural gas hydrate production by vertical wells fracturing

Clinical experiences of ultrasound-guided thoracolumbar interfascial plane block: a clinical experience.

Research on Property of Multicomponent Thickening Water Fracturing Fluid and Application in Low Permeability Oil Reservoirs

Experimental Study on the Effects of Pore Pressure and Slippage on the Permeability of a Fracture Network during Depressurization of Shale Gas Reservoir Production

Production induced fracture closure of deep shale gas well under thermo-hydro-mechanical conditions

Study on the Effect of Fracturing Fluid on the Structure and Mechanical Properties of Igneous Rock

A hydrate reservoir renovation device and its application in nitrogen bubble fracturing