Investigation of Microfluidic Co-Flow Effects on Step Emulsification: Interfacial Tension and Flow Velocities

Jiaoyuan Lian,Xiaoye Luo,Xing Huang,Yuehui Wang,Zhongbin Xu,Xiaodong Ruan

DOI: https://doi.org/10.1016/j.colsurfa.2019.02.040

IF: 5.518

2019-01-01

Colloids and Surfaces A Physicochemical and Engineering Aspects

Abstract:We propose a novel chip combining co-flow and step emulsification for flexible on-line control of droplet generation. Through this technique, we obtain controllable uniformly sized water in oil droplets. The droplet diameter is controlled between 101 and 1550 mu m and the generation frequency ranges from 0.32 to 100 Hz when using the new chip. Compared with conventional step emulsification, droplet dimension is reduced by more than 50% and throughput is increased up to a factor of 50 by using continuous phase co-flow within a certain range in the chip. We also simulate the effects of interfacial tension and flow velocities on emulsification. As continuous phase velocity increases, co-flow gradually replaces the Laplace pressure difference as the driving mechanism in step emulsification. Compared with step-emulsification, the effects of interfacial tension on droplet size and generation frequency greatly change when continuous phase co-flow is added. Co-flow causes both droplet diameter and generation frequency to increase with increasing dispersed phase velocity. Meanwhile, the driving mechanism changes from co-flow to Laplace pressure difference as the dispersed phase velocity increases, because of the increase in pinch-off distance. In addition, droplet generation changes from dripping to jetting as dispersed phase velocity increases. These effects of continuous phase co-flow on step emulsification are significant, and this technique can be easily used for tunable and high-throughput droplet production.