Abstract:To improve the ejector refrigeration cycle performance, this paper presents a theoretical thermodynamic analysis of a novel two-stage ejector refrigeration cycle (TSERC) with a gas-liquid separator using R134a/R32 and R600a/R290 as refrigerant. By separating the relatively low-boiling-point and high-boiling-point refrigerants, the cycle compression ratio decreases, the cycle performance increases, and the energy utilization efficiency can be improved. Energy and exergy analysis were conducted for the traditional single-stage ejector refrigeration cycle (SSERC) and TSERC. The effect of the mixture mass fraction on cycle performance under a fixed external heat source operating condition was studied, and the cycle performance comparisons between TSERC and SSERC at different evaporation temperature, condensation temperature and generation temperature were conducted. Results show that for TSERC, the maximum COP values 0.126 and 0.11, the maximum exergy efficiency 4.51 % and 4 % are obtained as the low-boiling-point mass fraction equals 0.6 and 0.4 respectively for R134a/R32 and R600a/R290. It is found that exergy destruction mainly occurs in the low-pressure sub-cycle of TSERC, the top three largest exergy destruction components are ejector 1, condenser 1 and generator 1, while the smallest exergy destruction occurs in pump 2. In addition, cycle performance comparison between SSERC and TSERC shows that the maximum COP improvement increased by 41.6 % and 89.6 % for 134a/R32 and R600a/R290 for TSERC, while the maximum entrainment ratio improvement increased by 32.4 % and 87.6 %. Moreover, it is concluded that the cycle performance improvement of TSERC is more significant at lower evaporation temperature, higher condensation temperature, and lower generation temperature compared to SSERC.

The Effects of Ejector Geometry Parameter and Refrigerant Charge Amount on an Ejector-Expansion Refrigeration System

A Comparative Study on Regulation Methods for Transcritical CO2 Ejector Expansion Refrigeration System.

Experimental Investigations on A R134a Ejector Applied in A Refrigeration System

Performance Study of an Enhanced Ejector Refrigeration Cycle with Flash Tank Economizer for Low-Grade Heat Utilization

Experimental investigation on two-phase driven ejector performance in a novel ejector enhanced refrigeration system

An Experimental Investigation on A Novel Ejector Enhanced Refrigeration Cycle Applied in the Domestic Refrigerator-Freezer

Investigation on A Two-Stage Ejection Refrigeration System

An Investigation on the Component Efficiencies of a Small Two-Phase Ejector

EXPERIMENTAL STUDY ON TWO TYPES OF TRANSCRITICAL CO2 HEAT PUMP WATER HEATER SYSTEM

Theoretical Study of A Transcritical Ejector Refrigeration Cycle with Refrigerant R143a

Theoretical Study on A Novel R32 Refrigeration Cycle with A Two-Stage Suction Ejector

Advanced Exergy Analyses of an Ejector Expansion Transcritical Co2 Refrigeration System

Performance Analysis of an Advanced Ejector-Expansion Autocascade Refrigeration Cycle

Initial Ratio Optimization for the Ejector Cooling System with Thermal Pumping Effect (ECSTPE)

Numerical investigation in effects of refrigerants' thermodynamic properties on performance of supersonic ejector

Performance Evaluation of an Ejector Subcooling Refrigeration Cycle with Zeotropic Mixture R290/R170 for Low-Temperature Freezer Applications

Effect of Mixing Chamber Diameter on Performance of Transcritical CO2 Heat Pump System with Ejector

Performance evaluation and energy-saving potential comparison of a heat-powered novel compression-enhanced ejector refrigeration cycle with an economizer

Effects of Operating Conditions and Geometries on the Performance of Nitrogen Ejectors for Joule–Thomson Cooling

Investigation on key geometries optimization and effect of variable operating conditions of a transcritical R744 two-phase ejector

Energy and Exergy Analysis of a Novel Two-Stage Ejector Refrigeration Cycle Using Binary Zeotropic Mixtures{fr}analyse De L’énergie Et De L'exergie D'un Nouveau Cycle De Réfrigération À Éjecteur À Deux Étages Utilisant Des Mélanges Zéotropes Binaires