Abstract:Tungsten oxide (WO3) is a strong candidate as the photoanode in photoelectrochemical (PEC) water splitting owing to its moderate band gap (2.6–3.2 eV) for wide light absorption and stable physicochemical properties. This work reports a morphology engineering strategy to fabricate voltage-induced terrace-like tungsten oxide (TW) film and its high-voltage performance as a photoanode for PEC water splitting. By controlling the anodization voltage, the morphology of the anodic WO3 film was altered, and their photoelectrochemical performances were compared. Anodization of the tungsten film in fluoride-containing H3PO4 leads to the growth of either irregular porous tungsten oxide layers or terrace-like tungsten oxide layers, depending on the anodic potentials. The possible growth mechanism of the porous oxide layer during anodization is proposed with a combination of the field-assisted dissolution model and the oxygen-bubble mold model. Under light irradiation, the photocurrent density was 3.0 mA cm–2 at 1.23 V vs RHE (VRHE) for annealed terrace-like WO3, which was almost 3 times larger than that of annealed porous WO3. As a photoanode, terrace-like WO3 films could generate hydrogen at 58 μmol cm–2 h–1 under simulated solar light, while porous WO3 films produced hydrogen with a slower rate of 28 μmol cm–2 h–1. The terrace-like WO3 films experience higher photoelectrochemical performance and incident photon-to-electron conversion efficiency (IPCE) than porous WO3 due to more regular nanostructure, smaller band gap, fast charge-transfer rate, and alleviated recombination rate. This study shows that morphology control can effectively enhance the photocurrent density and IPCE of photoanodes and suggests a practical direction for finding the optimal WO3 films for PEC water splitting.

Epitaxial growth of WO3 nanoneedles by flame: engineering of hole transport and water oxidation reactivity

Efficient and Controllable Flame Method to Generate Rich Oxygen Vacancies in WO3 Nanosheet Arrays to Enhance Solar Water Oxidation

ALD-based hydrothermal facile synthesis of a dense WO<sub>3</sub>@TiO<sub>2</sub>-Fe<sub>2</sub>O<sub>3</sub> nanodendrite array with enhanced photoelectrochemical properties

Promoting Photogenerated Holes Utilization in Pore-Rich WO3 Ultrathin Nanosheets for Efficient Oxygen-Evolving Photoanode

Wo3 Nanoflakes for Enhanced Photoelectrochemical Conversion

Oxygen vacancy engineering with flame heating approach towards enhanced photoelectrochemical water oxidation on WO3 photoanode

Large-Scale Tunable 3D Self-Supporting WO3 Micro-Nano Architectures As Direct Photoanodes for Efficient Photoelectrochemical Water Splitting.

Synthesis of WO3@ZnWO4@ZnO-ZnO Hierarchical Nanocactus Arrays for Efficient Photoelectrochemical Water Splitting

Surface tuning for promoted charge transfer in hematite nanorod arrays as water-splitting photoanodes

One-Step Rapid and Scalable Flame Synthesis of Efficient WO3 Photoanodes for Water Splitting.

Engineering Single-Atomic Ni-N4-O Sites on Semiconductor Photoanodes for High-Performance Photoelectrochemical Water Splitting

Oxygen vacancy-mediated WO3 phase junction to steering photogenerated charge separation for enhanced water splitting

In Situ Growth of Fe2WO6 on WO3 Nanosheets to Fabricate Heterojunction Arrays for Boosting Solar Water Splitting.

Facile Synthesis of a Micro–Nano-Structured FeOOH/BiVO4/WO3 Photoanode with Enhanced Photoelectrochemical Performance

High-Voltage Etching-Induced Terrace-like WO 3 Photoanode for Efficient Photoelectrochemical Water Splitting

Rational and Scalable Fabrication of High-Quality Wo3/Cds Core/Shell Nanowire Arrays for Photoanodes Toward Enhanced Charge Separation and Transport under Visible Light

Preparation of well-aligned WO 3 nanoflake arrays vertically grown on tungsten substrate as photoanode for photoelectrochemical water splitting

Tuning the Carrier Transfer Behavior of Coaxial ZnO/ZnS/ZnIn2 S4 Nanorods with a Coherent Lattice Heterojunction Structure for Photoelectrochemical Water Oxidation

Integrating transition metal phosphide catalysts on WO3 photoanodes enabling robust photoelectrocatalytic water oxidation

Engineering Single-Atomic Ni-N 4 -O Sites on Semiconductor Photoanodes for High-Performance Photoelectrochemical Water Splitting

Efficient Photoelectrochemical Water Splitting and Impedance Analysis of WO3−x Nanoflake Electrodes