Abstract:Presently Si-based field-effect transistors (FET) are approaching their physical limit and challenging Moore's law for their short-channel effect, and further scaling their gate length down to the sub-10 nm region is becoming extremely difficult. Two-dimensional (2D) layered semiconductors with atom-scale uniform thicknesses and absence of dangling bonds on the interface are considered as potential channel materials to support further miniaturization and integrated electronics. Wu F, et al. (2022 Nature 603 259) have successfully fabricated a FET with gate lengths below 1 nm using atomically thin molybdenum disulfide with exceptional device performance. This breakthrough has greatly encouraged further theoretical predictions regarding the performance of 2D devices. Additionally, 2D SnS exhibits high carrier mobility, anisotropic electronic properties, and stabilized in ambient condition conducive to advanced applications in 2D semiconductor technology. Herein, we explore the quantum transport properties of sub-5 nm monolayer (ML) SnS FET using first-principles quantum transport simulation. Considering the anisotropic electronic SnS, the double-gated-two-probe device model is constructed along the armchair and zigzag directions of ML SnS. After test five kinds of doping concentrations, a doping concentration of 5×10 13 cm -2 is the best one for SnS FET. We also used the underlap (UL) with range of 0, 2, and 4 nm to improve the device performance. On-state current ( I on ) is an important parameter for evaluating the transition speed of a logic device. A higher I on of a device can help to increase the switching speed of high-performance (HP) servers. The main conclusions are as follows. 1) I on of the n-type 2 nm (UL=4 armchair), 3 nm (UL=2), 4 nm (UL=3), 5 nm (UL=0) and the p-type 1 nm (UL=2 zigzag), 2 nm (UL=2 zigzag), 3 nm (UL=2,4 zigzag), 4 nm (UL=2,4 zigzag), and 5 nm (UL=0, armchair/zigzag) gate-length devices can meet the standards for HP applications for the next decade in the International Technology Roadmap for semiconductors (ITRS, 2013 version). 2) I on of the n-type device along the armchair direction (31-2369μA/μm) are larger than that in the zigzag direction (4.04-1943μA/μm), while p-type along the zigzag direction (545-4119μA/μm) are larger than that in the armchair direction (0.7-924μA/μm). Therefore, the p-type ML GeSe MOSFETs have a predominantly anisotropic current. 3) I on of the p-type 3 nm gate-length (UL=0) device along the zigzag direction has the highest valued 4119 μA/μm is 2.93 times larger than that in the same gate-length UL=2 (1407μA/μm). Hence, an overlong UL will weaken the performance of the device because the gate of the device cannot well control the UL region. Thus, a suitable length of UL for FET is very important. 4) Remarkably, I on of the p-type devices (zigzag), even at a 1 nm gate-length, can fulfill the requirements of HP applications for the next decade in the ITRS, with a value as high as 1934 μA/μm. To our knowledge, this is the best-performing device material reported at 1 nm gate length. 5) Subthreshold swing (SS) evaluates the control ability of the gate in the subthreshold region. The better the gate control, the smaller SS the device has. The limit of SS for traditional FETs is 60 mV/dec (at room temperature). Values of SS for ML SnS FET alone zigzag direction are less than those along the armchair direction because the leakage current is influenced by the effective mass.

Sub 10 nm Bilayer Bi 2 O 2 Se Transistors

High-performance Sub-10 Nm Monolayer Bi2O2Se Transistors

Quantum transport simulations of sub-5 nm bilayer Ga2O3transistor for high-performance applications

Bilayer TeO2: The First Oxide Semiconductor with Symmetric Sub-5-nm NMOS and PMOS

Bilayer Tellurene: A Potential p‐Type Channel Material for Sub‐10 nm Transistors

Many-Body Effect and Device Performance Limit of Monolayer InSe.

Sub-10 Nm Two-Dimensional Transistors: Theory and Experiment

Performance Upper Limit of sub-10 nm Monolayer MoS2 Transistors

Ballistic two-dimensional InSe transistors

Sub-5 Nm Monolayer Germanium Selenide (gese) MOSFETs: Towards a High Performance and Stable Device.

Pervasive Ohmic Contacts in Bilayer Bi2O2Se–Metal Interfaces

High-Performance Sub-10 Nm Two-Dimensional SbSeBr Transistors Through Transport Orientation.

Unusual Fermi‐Level Pinning and Ohmic Contact at Monolayer Bi2O2Se–Metal Interface

Sub-5-nm Ultra-thin In_2O_3 Transistors for High-Performance and Low-Power Electronic Applications

Sub-5 nm Gate-Length Monolayer Selenene Transistors

Promising Properties of Sub-5 nm Monolayer MoSi2N4 Transistor

First-Principles-Based Quantum Transport Simulations of High- Performance and Low-Power MOSFETs Based on Monolayer Ga2O3

Sub-5 nm Ultrathin In2O3 Transistors for High-Performance and Low-Power Electronic Applications

Performance Limit of Monolayer WSe2 Transistors; Significantly Outperform Their MoS2 Counterpart

Performance Limit of Monolayer WSe₂ Transistors; Significantly Outperform Their MoS₂ Counterpart

High-performance Sub-5nm Monolayer Tin Sulfide (SnS) Field-effect Transistors: a First principles Study