Abstract:We analyze the basic structural units of simple reconstructions of the (111) surface of SrTiO3 using density functional calculations. The prime focus is to answer three questions: what is the most appropriate functional to use; how accurate are the energies; what are the dominant low-energy structures and where do they lie on the surface phase diagram. Using test calculations of representative small molecules we compare conventional GGA with higher-order methods such as the TPSS meta-GGA and on-site hybrid methods PBE0 and TPSSh, the later being the most accurate. There are large effects due to reduction of the metal d oxygen sp hybridization when using the hybrid methods which are equivalent to a dynamical GGA+U, which leads to rather substantial improvements in the atomization energies of simple calibration molecules, even though the d-electron density for titanium compounds is rather small. By comparing the errors of the different methods we are able to generate an estimate of the theoretical error, which is about 0.25eV per 1x1 unit cell, with changes of 0.5-1.0 eV per 1x1 cell with the more accurate method relative to conventional GGA. An analysis of the plausible structures reveals an unusual low-energy TiO2-rich configuration with an unexpected distorted trigonal biprismatic structure. This structure can act as a template for layers of either TiO or Ti2O3, consistent with experimental results as well as, in principle, Magnelli phases. The results also suggest that both the fracture surface and the stoichiometric SrTiO3 (111) surface should spontaneously disproportionate into SrO and TiO2 rich domains, and show that there are still surprises to be found for polar oxide surfaces.

Stable Adsorption of Single Gold Atoms on the SrTiO3(111)-(9 × 9) Reconstructed Surface

Reconstructions on SrTiO3(111) surface tuned by Ti/Sr deposition

Ideal, Defective, and Gold--Promoted Rutile TiO2(110) Surfaces: Structures, Energies, Dynamics, and Thermodynamics from PBE+U

Stabilizing Fe Single Atoms on Rutile-TiO2(110) Surface Via Atomic Substitution

Size and Shape Dependence of the Electronic Structure of Gold Nanoclusters on TiO2.

Structure and reactivity of a water-covered anatase TiO<sub>2</sub>(001) surface

Formation Of Sr Adatom Chains On Srtio3 (110) Surface Determined By Strain

Ordered Array of Single Au Adatoms with Remarkable Thermal Stability: Au/Fe3O4(001)

A reconstructed anatase (001)-1 × 4 surface and its reactivity.

Electronic Structures of the SrTiO3(110) Surface in Different Reconstructions.

Quasi long range ordered hole adatoms pairs on SrTiO3(110) (4x1) surface

A New Trick for an Old Support: Stabilizing Gold Single Atoms on LaFeO3 Perovskite

Formation of Sr Adatom Chains on SrTiO3(1 1 0) Surface Determined by Strain

The Small Unit Cell Reconstructions of SrTiO3 (111)

Formation of Sr adatom chains on SrTiO3 (1 1 0) surface determined by strain

Active Sites for Adsorption and Reaction of Molecules on Rutile Tio2(110) and Anatase Tio2(001) Surfaces

Surface Structure for Au on (001) Srtio3

Identifying Atomic Geometry And Electronic Structure Of (2 X 3)-Sr/Si(100) Surface And Its Initial Oxidation

In-situ Measurements of Reconstructed Anatase TiO2(001)Surface by Variable-Temperature STM

Direct In-Situ Insights into the Asymmetric Surface Reconstruction of Rutile TiO2 (110)

Direct in-situ insights into the asymmetric surface reconstruction of rutile TiO 2 (110)