Abstract:This paper presents a 0.2 similar to 3.8-GHz in-band (IB) full-duplex (FD) mixer-first receiver based on a vector self-interference (SI) canceller. To ensure the wideband orthogonality of the reconstructed SI signal while minimizing the noise figure (NF) degradation in FD mode, a low insertion loss two-stage polyphase filter (PPF) with a lacking resistance and capacitance (LRC) structure is used in the SI canceller. A 6-bits passive capacitor digital to analog converter (C-DAC) attenuator not only realizes the high-precision amplitude adjustment of the reconstructed SI signal but also avoids the linearity limitation of the back-end modules of the canceller and reduces the noise contribution of the front-end modules at the canceller output. A four-phase mixer-first receiver with enhanced out-of-band (OOB) interference suppression is designed to provide sufficient linearity to reduce the SI-induced nonlinear distortion. As a proof of concept, a prototype FD receiver is fabricated in CMOS 65 nm technology and measured in chip-on-board (COB) package. Measurement results show that it can operate in the frequency range of 0.2 similar to 3.8-GHz with more than 25 dB SIC amount for 10 MHz bandwidth (BW) 64-QAM modulated signals in fixed (30 dB) channel attenuation test setup. The receiver achieves OOB input-referred third-order intercept point (OOB-IIP3) of +24 dBm and OOB input-referred second-order intercept point (OOB-IIP2) of +82 dBm at 1-GHz local oscillator (LO) frequency. In FD mode, the NF degradation is <= 1.5 dB. The effective IB-IIP3 and effective IB-IIP2 are enhanced by 15 dB and 28 dB, respectively. The power consumption of entire FD receiver including the SI canceller is less than 44 mW. The active chip area is 0.55 mm(2).

On-Chip Self-Interference Canceller with Variable Inductor Based Electrical Balance Network for Full Duplex Systems

A Highly-integrated Non-magnetic Passive Circulator Based on Rotary Traveling-wave Oscillator and Spatio-temporal Conductivity Modulation in 130 Nm CMOS

Three-solenoid Windings Transformer Baluns on CMOS-grade Silicon Substrate

An Ultra-Low Power K band Balanced Frequency Doubler with a Novel Current-reused Structure

A Novel Compact Dual-Band Antenna Array With High Isolations Realized Using the Neutralization Technique

Enhanced-Linearity Wideband Full-Duplex Receiver With Shared Self-Interference Canceller

Wideband Self-Adaptive RF Cancellation Circuit for Full-Duplex Radio: Operating Principle and Measurements

A 28 nm CMOS Dual-Band Concurrent WLAN and Narrow Band Transmitter With On-Chip Feedforward TX-to-TX Interference Cancellation Path for Low Antenna-to-Antenna Isolation in IoT Devices

Widely-Linear Digital Self-Interference Cancellation in Direct-Conversion Full-Duplex Transceiver

A 0.18 Um Cmos Programmable Interference Canceller For Cognitive Radio Front-End

Full Duplex Communication with Practical Self-Interference Cancellation Implementation

Optical Multi-Tap RF Canceller for In-Band Full-Duplex Wireless Communication Systems

Analog Self-Interference Cancellation with Practical RF Components for Full-Duplex Radios

Augmented Envelope Neural Networks on RF-SoC for Digital Self-Interference Cancellation

A 0.2~3.8-Ghz Full-Duplex Receiver with More Than 25 Db Self-Interference Cancellation Using a C-DAC-Based Vector Canceller.

A Wideband Full-Duplex Receiver with Multi-Domain Self-Interference Cancellation Based on Capacitor Stacking Delay and Delay Compensation in Cancellers

A Comprehensive Self-interference Model for Single-antenna Full-duplex Communication Systems

Modeling and Efficient Cancellation of Nonlinear Self-Interference in MIMO Full-Duplex Transceivers

A Low-Noise Dual-Path Self-Interference Cancellation Architecture for Watt-Level TX Power Handling in Simultaneous Transmit and Receive

A 0.5-to-3ghz Full-Duplex Receiver with 27db Self-Interference-Cancellation.

A 0.5-4Ghz Full-Duplex Receiver with Multi-Domain Self-Interference Cancellation Using Capacitor Stacking Based Second-Order Delay Cells in RF Canceller