Numerical Study of the Mixture Formation and Stratified-Flame-induced Auto Ignition (SFI) Combustion Processes in a Poppet-Valve Two-Stroke Direct Injection Gasoline Engine

Bang-Quan He,Lin,Xiao Li,Xinyan Wang,Hua Zhao,Yan Zhang
DOI: https://doi.org/10.1016/j.applthermaleng.2019.02.025
IF: 6.4
2019-01-01
Applied Thermal Engineering
Abstract:Two-stroke gasoline engines, as the substitutes of their four-stroke downsized counterparts, can mitigate knock, excessive thermal and mechanical loads for the improvement of fuel economy. But the combustion instability of the two-stroke gasoline engines at low loads is a dilemma. Flame propagation initiated by spark ignition combined with the auto-ignition of the mixture with high residual gas fraction during flame propagation, i.e., stratified-flame-induced auto-ignition (SFI) combustion, is one possible solution to control ignition timing and improve combustion stability of a two-stroke direct injection spark ignition gasoline engine at low loads. To understand the relationships between the mixture formation and SFI combustion event, simulation was conducted at a fixed amount of fuel burned in a cycle. The results show that engine speed affects flame propagation and auto-ignition in the cylinder through the change in the distribution of fuel and residual gases. SFI combustion can occur during flame propagation at different engine speeds. With the increase of engine speed, increased fuel moves towards the spark plug while the temperature of the mixture around the cylinder increases with residual gases, leading to increased heat released by SFI auto-ignition. Although increased engine speed leads to a delay in ignition timing, shortened combustion duration increases indicated mean effective pressure.
What problem does this paper attempt to address?