Abstract:Multispectral thermometry is based on the law of blackbody radiation and is widely used in engineering practice today. Temperature values can be inferred from radiation intensity and multiple sets of wavelengths. Multispectral thermometry eliminates the requirements for single-spectral and spectral similarity, which are associated with two-colour thermometry. In the process of multispectral temperature inversion, the solution of spectral emissivity and multispectral data processing can be seen as the keys to accurate thermometry. At present, spectral emissivity is most commonly estimated using assumption models. When an assumption model closely matches an actual situation, the inversion of the temperature and the accuracy of spectral emissivity are both very high; however, when the two are not closely matched, the inversion result is very different from the actual situation. Assumption models of spectral emissivity exhibit drawbacks when used for thermometry of a complex material, or any material whose properties dynamically change during a combustion process. To address the above problems, in the present study, we developed a multispectral thermometry method based on optimisation ideas. This method involves analysing connections between measured temperatures of each channel in a multispectral temperature inversion process; it also makes use of correlations between multispectral signals at different temperatures. In short, we established a multivariate temperature difference correlation function based on the principles of multispectral radiometric thermometry, using information correlations between data for each channel in a temperature inversion process. We then established a high-precision thermometry model by optimising the correlation function and correcting any measurement errors. This method simplifies the modelling process so that it becomes an optimisation problem of the temperature difference function. This also removes the need to assume the relationships between spectral emissivity and other physical quantities, simplifying the process of multispectral thermometry. Finally, this involves correction of the spectral data so that any impact of measurement error on the thermometry is reduced. In order to verify the feasibility and reliability of the method, a simple eight-channel multispectral thermometry device was used for experimental validation, in which the temperature emitted from a blackbody furnace was identified as the standard value. In addition, spectral data from the 468–603 nm band were calibrated within a temperature range of 1923.15–2273.15 K, resulting in multispectral thermometry based on optimisation principles with an error rate of around 0.3% and a temperature calculation time of less than 3 s. The achieved level of inversion accuracy was better than that obtained using either a secondary measurement method (SMM) or a neural network method, and the calculation speed achieved was considerably faster than that obtained using the SMM method.

Multispectral True Temperature Inversion Based on Multi-Objective Minimization Optimization Method

Multispectral Thermometry Method Based on Optimisation Ideas

Multi-Spectral Radiation Temperature Measurement: A High-Precision Method Based on Inversion Using an Enhanced Particle Swarm Optimization Algorithm with Multiple Strategies

Analysis of Multi-Factor on Measurement Improvement of an Infrared Imager in Low-Temperature Environments

High-precision temperature retrieval algorithm and verification for mesospheric airglow spectrum photometer

Multispectral two-dimensional temperature field reconstruction using particle swarm optimization and the Broyden–Fletcher–Goldfarb–Shanno algorithm with multiple extreme value optimization

High-Precision Temperature Inversion Algorithm for Correlative Microwave Radiometer

High-precision multi-spectral radiation thermometry method based on the improved grey wolf optimization algorithm inversion

An optimization algorithm for separating land surface temperature and emissivity from multispectral thermal infrared imagery

Multi-objective fractional-order particle swarm optimization algorithms for data processing of multi-wavelength pyrometer

Multiobjective particle swarm inversion algorithm for two-dimensional magnetic data

Data processing for simultaneous inversion of emissivity and temperature using improved CABCSMA and target-to-best DE algorithms in multispectral radiation thermometry (MRT)

Multidimensional high-temperature field measurement method for flame based on near infrared radiation spectrum of water vapor

Inverse analysis of non-uniform temperature distributions using multispectral pyrometry

Development and Validation of a Rapid Inverse Solver for Multiparameter Spectrophotometry Without Integrating Sphere

Multispectral radiation temperature data processing algorithm for high temperature complex material surface

Optimization analysis of multi-band pyrometry

A Minimized Mutual Information retrieval for simultaneous atmospheric pressure and temperature

Rapid inverse radiative transfer solver for multiparameter spectrophotometry without integrating sphere

Multi-parameters Optimization for Microchannel Heat Sink Using Inverse Problem Method

Land Surface Temperature Retrieval from Landsat 8 TIRS - Comparison between Radiative Transfer Equation-Based Method, Split Window Algorithm and Single Channel Method