Abstract:<p>In lateral crashes, thin-walled beams may collide with impactors with multifarious shapes and sizes at any position or angle. In addition, the beams are always fixed on other structural components. However, these facts are ignored in the present studies on the bending collapse. This paper aims to investigate the influences of such factors on the transverse bending responses of thin-walled beams. Quasi-static three-point bending tests are conducted first for aluminum square beams loaded at different load angles, positions and spans. The non-linear finite element code LS-DYNA is then utilized to simulate the tests. After validated by the experiment, the finite element model is employed to perform parametric studies to investigate the influences of various factors on collapse responses of thin-walled tubes, and the ranges of the force responses with the variation of these factors are discussed. Results show that the variation of punch shape and size, load position and angle may lead to the switch of deformation modes, while the loading velocity and the height of crash boxes have very small influences on the deformation patterns. Increasing the loading velocity results in a much higher peak force, and fixing the beams on shorter crash boxes achieves a higher force level. In all cases, a sharp punch perpendicularly loaded in the middle of the span controls the lower bound of the crushing force, while the upper bound is governed by the punch approaching the support with small angles. The mean crushing force of the beams can be increased by up to 78% with the variation of the load and boundary factors in the calculations. The findings of this work would be helpful on the crashworthiness design of thin-walled beams under transverse loads.</p>

Three-point bending of thin-walled rectangular section tubes with indentation mode

Three-point bending collapse of thin-walled rectangular beams

Bending collapse of square tubes with variable thickness

Energy Absorption and Optimization Design of Multi-Cell Tubes Subjected to Lateral Indentation

Transverse crush of thin-walled rectangular section tubes

Dynamic Performances of Thin-Walled Tubes with Star-Shaped Cross Section under Axial Impact

Behavior of Thin-Walled Dodecagonal Section Double Skin Concrete-Filled Steel Tubes under Bending

FLEXURAL BEHAVIOUR OF THIN-WALLED DODECAGONAL SECTION DOUBLE SKIN CONCRETE-FILLED STEEL TUBES

Experimental Investigation and Design of Thin- Walled Concrete-Filled Steel Tubes Subject to Bending

Bending Strength of Thin-Walled Centrifugal Concrete-Filled Steel Tubes

Axial crushing of tubes fabricated by metal sheet bending

Non-affine bending mode of thin cylindrical tubes

Bending resistance of thin-walled multi-cell square tubes

Bending Collapse of Folded Tubes

New theoretical models for the bending moment of thin-walled beams under three-point bending

Theoretical Analysis on the Collapse of Dumbbell-Shaped Tubes

On the bending force response of thin-walled beams under transverse loading

Lateral Compression Behaviors of Thin-Walled Equilateral Triangular Tubes

Buckling and Energy Absorption of Novel Pre-Folded Tubes under Axial Impacts

Quasi-static Axial Compression of Thin-Walled Tubes with Different Cross-Sectional Shapes

Optimization for Bending Collapse of Thin-Walled Twelve Right-Angle Section Tubes with Variable Thickness