Abstract:This paper presents a comparison between two design methodologies applied to permanent magnet synchronous machines for hybrid and electric vehicles (HEVs and EVs). Both methodologies are based on 2D finite element models and coupled to a genetic algorithm to optimize complex non-linear geometries such as multi-layer permanent magnet machines. To reduce the computation duration to evaluate Induced Voltage and Iron Losses for a given electrical machine configuration, a new methodology based on geometrical symmetries and magnetic symmetries are used and is detailed. Two electromagnetic models have been developed and used in the design stage. The first model was the stepped rotor position finite element analysis called abc model which considered the spatial harmonics without any approximation of the waveform of flux linkage inside the stator, and the second model was based on a fixed rotor position called dq model, with the approximation that the waveform of flux linkage inside the stator was sinuous. These two methodologies are applied to the design of a synchronous machine for HEVs and EVs applications. Design results and performances are analyzed, and the advantages and drawbacks of each methodology are presented. It was found that the dq model is at least 5 times faster than the abc model with high precision for both the torque and induce voltage evaluation in most cases. However, it is not the case for the iron losses computation. The iron loss model based on dq model is less accurate than the abc model with a relative deviation from the abc model greater than 70% at high control angle. The choice of the electromagnetic model during the optimization process will therefore influence the geometry and the performances of the obtained electrical machine after the optimization.

Analytical Derivation of Efficiency Map of an Induction Machine for Electric Vehicle Applications

Study on Efficiency Calculation Model of Induction Motors for Electric Vehicles

Efficiency Map Calculation for Surface-Mounted Permanent-Magnet In-Wheel Motor Based on Design Parameters and Control Strategy

Hybrid Analytical Model for Predicting the Electromagnetic Losses in Surface-Mounted Permanent-Magnet Motors

Fast Evaluation of Driving Cycle Efficiency of Interior Permanent Magnet Synchronous Machines for Electric Vehicles Considering Step-Skewing

A Utility and Accurate Electrical Loss Model and Application for Induction Motors Utilizing 2-D Finite Element Analysis

Assessment of Iec 60034-2-1 in Determining Induction Machine Efficiency

Analytical Calculation of Eccentric Surface-Mounted Permanent-Magnet Motor Accounting for Iron Saturation

A Hybrid Methodology for Analyzing the Performance of Induction Motors with Efficiency Improvement by Specific Commercial Measures

Generic machine identification and maximum efficiency operation of induction machines

Iron Loss and Efficiency Analysis of Interior PM Machines for Electric Vehicle Applications

Design Optimization of Multi-Layer Permanent Magnet Synchronous Machines for Electric Vehicle Applications

Inductive Electrically Excited Synchronous Machine for Electrical Vehicles—Design, Optimization and Measurement

Reluctance Torque Analysis and Reactance Calculation of IPM for HEVs Based on FEM

An efficiency optimization strategy of induction motors for electric vehicles

Rotor Slots Design of Induction Machine for Hybrid Electric Vehicle Drives

Operating Control of Efficiently Generating Induction Motor for Driving Hybrid Electric Vehicle

Constant-Power Operation Performance Improvement of the Induction Machine Drives for Hybrid Electric Vehicle Applications

A Hybrid Analytical Mothod for On-Load Performance Prediction of Delta-Type IPM Motors Based on Equivalent Air-Gap Function

Analysis and Calculation Method of Saturated Inductance of a Dual-Three Phase Permanent-Magnet Synchronous Machine for Electric Vehicles

Improved Harmonic Iron Loss and Stator Current Vector Determination for Maximum Efficiency Control of PMSM in EV Applications