Abstract:The ash fusion temperature of coal at high temperature is an important parameter for the efficient and safe operation of coal gasifiers. The equipment of ash fusion temperature was used to measure the ash fusion temperatures of the oxide components composed of SiO2, Al2O3, Fe2O3, MgO, and CaO with different proportions. Five variables composed of Si/Al, Si+Al, Fe2O3, MgO, and CaO were selected to verify the effect of the change on the coal ash fusing characteristics and the range of variables cover most domestic coal ash. Factsage was used to calculate the liquidus temperature of coal ash components, and to obtain the solid phase ratios of each crystal in each slag system and the simulation results are verified by experiments. With the contents of CaO, Fe2O3 and Si/Al increase, the ash fusion temperature gradually decreases while with the content increasing of Si+Al and MgO, the ash fusion temperature of the coal ash gradually increases. The ash fusion temperature varied with the contents of the oxide components and was closely related to the corresponding liquidus temperature, which was always higher than the ash fusion temperature about 200℃. Factsage was also used to predict the crystal compositions of the slag system at different temperatures. It could be concluded that there was no necessary relationship between the transformation of different slag systems with the change of a certain variable, and further analysis was needed for the slag system dominated by a specific factor. In the crystal phase experiment, after the slag was fused, quenching could be performed quickly to maintain the original crystal form at the high temperature. When X-ray diffraction analysis was completed, the precipitation ratios of different crystals at various temperatures could be obtained, which was in good agreement with the simulation results. The differences between the simulation and experimental results were also explored. The effects of different oxide compositions on the slag solidification ratios were investigated. The conclusion of this paper lays a foundation for further analysis of the product and characteristics of the molten state of multi-oxide system, and is of great significance for the optimization design operation of gasifier.

Fusion Properties of Gasified Fine Ash at High Temperature under Reducing Atmosphere. Part 2: Influence of Fe2O3

Effect of Chemical Compositions on Ash Fusibility Characterization of a Jincheng Anthracite During Combustion and Gasification

Mechanism of Na2O/CaO Ratio Affecting Ash Fusing Characteristics During Ash Deposition and Slagging in Municipal Solid Waste Incinerator

Ash Fusion Characteristics and Mineral Evolvement of Blended Ash Under Gasification Condition

Effecting mechanisms of iron-rich sludge on ash fusion characteristics of coal with high ash fusion temperature under reducing atmosphere

Quantitative analysis of minerals of blended coal ash at high temperature and its influence on slagging

Ash fusion temperature and crystal composition of multi-component coal ash

Influence of Ash Composition on the Sintering Behavior During Pressurized Combustion and Gasification Process

Decarburization and ash characteristics during melting combustion of fine ash from entrained-flow gasifier

Melting Characteristics of Coal Ash and Properties of Fly Ash to Understand the Slag Formation in the Shell Gasifier

Co-melting mechanisms for municipal solid waste incineration fly ash with fine slag from coal gasification and coal gangue

Ash Fluidity and Regulation Mechanism of Iron-Rich Low-Rank Coal in High-Temperature Gasification Process

Effect of High Calcium and High Iron Coal on Ash Fusion Characteristics of Petroleum Coke during Cogasification

Study on Coal Ash Fusion Characteristics with TG-DSC Method

Relationship Between Coal Ash Composition and Ash Fusion Temperatures

Ash Fusion Regulation Mechanism of Coal with Low Melting Point and Different Ash Compositions

Study on the Coal Ash Fusibility During Blending Coal Combusition

Mineral Conversion of Coal-ash in Fusing Process and the Influence to Ash Fusion Point

Influence Of Coal Blending On Ash Fusibility In Reducing Atmosphere

Effect of different additives on ash fusion characteristic and mineral phase transformation of iron-rich Zhundong coal

Improvement of the Coal Ash Slagging Tendency by Coal Washing and Additive Blending with Mullite Generation