Abstract:Good gas permeability is an essential factor for the smooth operation and high performance in the lower part of the blast furnace. Under the present low carbon blast furnace smelting conditions, the coke layer is thinner, and the proportion of the molten metal in the coke layer is significantly higher, resulting in a major reduction in gas permeability, which seriously affects blast furnace operations. Also, the lower thickness of the coke layer weakens the process of solid-liquid carbon dissolution when the molten iron passes through the coke layer, which reduces the carbon content of the molten iron and further deepens the erosion of the refractory by the unsaturated molten iron. The carbon dissolution in the molten iron in a blast furnace core was measured by a high-temperature vacuum wettability test tool that analyzed the interface wetting activity between Fe−C melts with specific carbon mass fraction (3.8%, 4.3%, 4.8%) and 99.9% of high temperatures graphite plates. Besides, the scanning electron microscope (SEM) and energy dispersive spectroscopy (EDS) were used to analyze the graphite substrate’s carburizing morphology and carburizing distances. The results show that, with the increase of carbon content, the interface contact angle becomes bigger. The contact angle decreases with time, and eventually reaches a steady-state during the melting process, and the Fe−C melt with saturated carbon cannot be wet. The scanning electron microscopy analysis shows that a spherical cap-like depression is created by a cross-section of the Fe−C melt and the graphite substrate, and the radius and volume of the depression decrease with increasing carbon content. The study of the EDS scanning analysis shows that the amount of dissolved carbon atoms in the graphite substrate penetrates the Fe−C melt and decreases with increasing initial carbon concentration. The smaller the carburizing effect, the better the wetting is conducive to carbon mass transfer. It is found that by measuring carburizing of the carbon atoms in the graphite substrate into the Fe−C melt by calculating the surface energy reduces the surface energy between the two. Thus, the surface tension decreases and the melt spreads slowly with contact angle gradually decreasing during melting.

Effect of High Calcium and High Iron Coal on Ash Fusion Characteristics of Petroleum Coke during Cogasification

Effect of Chemical Compositions on Ash Fusibility Characterization of a Jincheng Anthracite During Combustion and Gasification

Effects of sodium and potassium on fusion characteristics of petroleum coke ash with high vanadium and nickel

The Mechanism of the Ash Fusion Characteristics of Gasification Coke Affected by SiO 2 /al 2 O 3 Ratio and CaO Content in Blending Coals

Effecting mechanisms of iron-rich sludge on ash fusion characteristics of coal with high ash fusion temperature under reducing atmosphere

Quantitative analysis of minerals of blended coal ash at high temperature and its influence on slagging

Ash fusion behavior modification mechanisms of high-calcium coal by coal blending and its ash viscosity predication

Melting Characteristics of Coal Ash and Properties of Fly Ash to Understand the Slag Formation in the Shell Gasifier

Ash fusion temperature and crystal composition of multi-component coal ash

Effect of different additives on ash fusion characteristic and mineral phase transformation of iron-rich Zhundong coal

Ash Fusion Characteristics and Mineral Evolvement of Blended Ash Under Gasification Condition

Interface Wetting Behavior Between Iron and Coke During the Carbon Dissolution Process in a Blast Furnace

Effect of Temperature and Pressure on the Mineralogical and Fusion Characteristics of Jincheng Coal Ash in Simulated Combustion and Gasification Environments

Effect of Al2O3/CaO on the melting and mineral transformation of Ningdong coal ash

Investigation on variation mechanisms of ash fusion and viscosity of high calcium-iron coal by coal blending

Evolution of Coke Microstructure and Metallurgical Properties During Graphitization in a Blast Furnace

Effect of Coal Ash on the Reduction and Roasting Processes of Phosphogypsum

Ash Fluidity and Regulation Mechanism of Iron-Rich Low-Rank Coal in High-Temperature Gasification Process

Influence Of Coal Blending On Ash Fusibility In Reducing Atmosphere

Assessment on the effect of unburned pulverized coal on the properties of coke in blast furnace

Effects of phosphorous-based additive on flow properties of high silicon-aluminum coal ash