Abstract:In low-voltage dc distribution networks (DDNs), the load terminals typically employ voltage-source inverters to provide ac supply to the consumers. These load terminals can potentially experience poor voltage regulation especially in the presence of intermittent photovoltaic sources and uncoordinated charging patterns of plugged-in electric vehicles. Variations in power absorption and generation at different points can potentially create significant voltage drop/rise at the load terminals and may reduce the power quality at the ac side of the loads. In order to mitigate this issue, this article suggests a real-time coordinated supervisory control strategy that estimates the present state of the network and generates a set of references for the controllable sources such that the load voltage deviations are minimized. This article also proposes a power-electronic-converter-based soft open point (SOP) that provides a seamless connection of the remote end and gives an additional degree of freedom to control the circulating current among the feeders. Detailed description and control strategy of the SOP is presented. Steady-state analysis carried out on a three-feeder DDN is presented with and without the proposed SOP. Real-time simulation with an Ethernet-based transmission control protocol/Internet protocol communication system along with experimental results is presented to validate the implementation and effectiveness of the control strategy.

The Steady-State and Fault Ride-Through Control Strategies of Soft Normally Open Point in Distribution Network

Optimal Configuration for Soft Open Point Based on Scenario Generation of Wind Power and Photovoltaic Output

A Control Strategy for Enhanced Operation of SNOP under Transient Disturbances and Network Faults

A Seamless Transfer Control Strategy of SNOP for the Critical Load Safety under Network Faults

Self-healing Control Strategy Based on SNOP under Severe Fault Condition

An Adaptive Power Control Method for Soft Open Points Based on Virtual Impedance

Control strategies for active distribution networks based on soft open point

Coordination Control Strategy for Power Management of Active Distribution Networks.

Research on Topology and Control Technology of Soft Multi-State Open Point with Fault Isolation Capability

The Adaptive Power Compensation Strategy of Soft Open Point to Support Bus Voltage under Faults

A control strategy for soft open points based on adaptive voltage droop outer-loop control and sliding mode inner-loop control with feedback linearization

Real-Time Coordinated Control of Low-Voltage DC Distribution Network With Soft Opening Point

Short-Circuit Fault Protection Scheme for Serial-Shunt Type Soft Normally Open Point

A Two-Layer Control Strategy for Soft Open Points Considering the Economical Operation Area of Transformers in Active Distribution Networks

Optimized Two-Time Scale Robust Dispatching Method for the Multi-Terminal Soft Open Point in Unbalanced Active Distribution Networks

Control Strategy of Multi-level Converters for Soft Open Point Applications

General Small-Signal Modeling and Parameter Optimization of the Soft Normally-Open Point Connected to the Distribution Network

Operating principle of Soft Open Points for electrical distribution network operation

Research On An Improved Droop Control Strategy For Soft Open Point

Switching Technology of Three-Terminals Soft Open Point Control Mode

An Overview of Soft Open Points in Electricity Distribution Networks