Abstract:Ceramic core is an essential component in the precise casting of hollow turbine blades, and the investigation on 3D printing of silica-based ceramic cores is crucial to the development of aviation industry; however, they are suffered from difficulty in high-temperature strength and structural anisotropy. In present work, silica-based ceramic cores were prepared via DLP stereolithography 3D printing, and the anisotropy management on microstructures and properties were explored based on the particle size of fused silica powders. In 3D printed ceramic cores with coarse powders, significant anisotropy was displayed exhibiting multilayer structure with large gaps in horizontal printing and uniform porous microstructure in the vertical direction, which was further explained by the particle deposition in printing. With finer silica powders, the uniformity in the microstructures was highly improved, attributed to the enhanced particle dispersion in ceramic slurries and promoted interlayer particle rearrangement during sintering. To evaluate the anisotropy in mechanical property, the ratio of vertical strength to horizontal strength (σV/σH) was proposed, which rose from 0.48 to 0.86 as the particle size decreased from 35 μm to 5 μm, suggesting enhanced mechanical uniformity. While the average particle size of silica powders was 5 μm, the flexure strengths of ceramic cores in different directions were up to 18.5 MPa and 16.3 MPa at 1540°C with σV/σH ratio of 0.88, which well satisfied the demands for the casting of turbine blades. This work inspires new guidance on the anisotropy management in ceramic cores prepared by 3D printing, and provides new technology for fabrication of silica-based ceramic cores with superior high temperature mechanical properties.

A strategy for defects healing in 3D printed ceramic compact via cold isostatic pressing: Sintering kinetic window and microstructure evolution

Defect inhibition mechanism of 3D‐printed ceramics via synergetic resin composition and debinding processing regulation

Formation mechanism and controlling strategy of lamellar structure in 3D printed alumina ceramics by digital light processing

POLYMER-DERIVED SIC CERAMIC WITH TRIPLY PERIOD MINIMAL SURFACE STRUCTURE FABRICATION THROUGH DIGITAL LIGHT PROCESSING

Ultrahigh Strength of Three-Dimensional Printed Diluted Magnesium Doping Wollastonite Porous Scaffolds

3D printing of dense structural ceramic microcomponents with low cost: Tailoring the sintering kinetics and the microstructure evolution

Asynchronous Densification of Zirconia Ceramics Formed by Stereolithographic Additive Manufacturing

4D printing of ceramic structures

UV-Curing Assisted Direct Ink Writing of Dense, Crack-Free, and High-Performance Zirconia-Based Composites With Aligned Alumina Platelets

The influence of sintering procedure and porosity on the properties of 3D printed alumina ceramic cores

Structure design influencing the mechanical performance of 3D printing porous ceramics

Digital light processing‐based additive manufacturing of orientation‐controlled Al2O3 ceramics with improved damage tolerance

Impact of Sintering Aid Type and Content on the Mechanical Properties of Digital Light Processing 3D-Printed Si3N4 Ceramics

Anisotropy management on microstructure and mechanical property in 3D printing of silica-based ceramic cores

Optimizing the properties of vat photopolymerization 3D-printed SiC ceramics by multi-infiltration

Preparation of excellent performance ZTA ceramics and complex shaped components using digital light processing 3D printing technology

Ultrastrong and damage-tolerant ceramic architectures via 3D printing

Microstructure and mechanical properties of 3D‐printed zirconia bone scaffold: Experimental and computational analysis

Reinforcement effect in printing precision and sintering performance for liquid crystal display stereolithography additive manufacturing of alumina ceramics

Effect of Holding Time During Sintering on Microstructure and Properties of 3D Printed Alumina Ceramics

Microstructure and properties evolution of silicon-based ceramic cores fabricated by 3D printing with stair-stepping effect control