Abstract:To fully benefit from advanced CMOS technologies, it is desirable to completely digitize the transmitter, which yields reduced die area, highly efficient operation and direct interface to digital baseband. However, the ever-increasing data demand with complex OFDM and wideband high-order modulation poses great challenges on transmitter output power, efficiency and linearity. The quadrature and polar digital transmitters (DTXs) are two types of widely-used architectures: the quadratur e DTX is suitable for wideband signals but the orthogonal vector combination limits output power and efficiency [1, 2]; the polar DTX has advantages of high output power and efficiency, but it requires extra design complexity of phase modulators and AM-PM synchronization [3, 4]. Moreover, the switch-based digital power amplifier (DPA) driven by square-wave LOs will generate significant unwanted odd harmonic components, where the 3 <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">rd</sup> harmonic usually falls in the crowded sub-6GHz band and potentially interferes with other terminals. In this work, a 6-phase cell-reused DTX driven by 1/3 duty-cycle LO signals is proposed, which approaches the output power range of polar counterparts and realizes 18 efficiency peaks on the complex plane. By introducing a multi-phase injection-locked ring oscillator (ILRO) as an accurate, low-jitter and low-power solution for multi-phase LO generation (MPLG), this DTX achieves good 3 <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">rd</sup> -order harmonic rejection (HR3) and linearity performance.

Design and Analysis of Two-Stage Harmonic Rejection Mixers with 16-Phase LO

A 0.1–1.5GHz harmonic rejection receiver front-end with hybrid 8 phase LO generator, phase ambiguity correction and vector gain calibration

A 0.1–1.5 GHz Harmonic Rejection Receiver Front-End with Phase Ambiguity Correction, Vector Gain Calibration and Blocker-Resilient TIA

A 0.1–1.5G SDR Transmitter with Two-Stage Harmonic Rejection Power Mixer in 65-Nm CMOS

A 60–90 GHz Mixer-First Receiver with Adaptive Temperature-Compensation Technique

Design of A X-Band Image Rejection Balanced Mixer

A 100M–1.5 GHz harmonic-rejection SDR receiver front-end

A Reconfigurable Local Oscillator Harmonic Mixer with Simultaneous Phase Shifting and Image Rejection

A SAW-less 0.5–2.5 GHz receiver front-end with 80 dB 3rd order harmonic rejection ratio

Design of a 24-30-GHz High-Linearity Down-Conversion Mixer

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

A Sub-6GHz Wideband Transmitter with LO Harmonic Rejection RF Front-ends Using Frequency-Adaptive Calibration

A Low Power 0.4-1 Ghz Receiver Front-End with an Enhanced Third-Order-Harmonic-Rejecting Series N-Path Filter

A Low Power Sub-harmonic Self-Oscillating Mixer with 16.8dB conversion loss at 310GHz in 65nm CMOS

A Reconfigurable IF Receiver Supporting Intra-Band Non-Contiguous Carrier Aggregation in 65 Nm CMOS.

Analysis and Design of a Broadband SiGe HBT Image-Reject Mixer Integrating Quadrature Signal Generator

A Reusable Superheterodyne Dual-Band Down-Conversion Mixer With Hybrid Linearity-Enhanced Technique for 5G Non-Contiguous Multiband NR

Design of A 664ghz Wideband Sub-Harmonic Mixer Based on Master Technology

An X-band Low Phase Noise Oscillator with High Harmonic Suppression Using SIW Quarter-Wavelength Resonator

A 62-90 GHz High Linearity and Low Noise CMOS Mixer Using Transformer-Coupling Cascode Topology

4.4 A Highly-Integrated 6-Phase Cell-Reused Digital Transmitter Using 1/3 Duty-Cycle LO Signals for Harmonic Rejection.