Abstract:Human being faces two key problems: world-wide energy shortage and global climate worming. To reduce energy consumption and carbon emission, it needs to develop high efficiency heat transfer devices. In view of the fact that the existing enhanced technologies are mostly developed according to the experiences on the one hand, and the heat transfer enhancement is normally accompanied by large additional pumping power induced by flow resistances on the other hand, in this chapter, the field synergy principle for convective heat transfer optimization is presented based on the revisit of physical mechanism of convective heat transfer. This principle indicates that the improvement of the synergy of velocity and temperature gradient fields will raise the convective heat transfer rate under the same other conditions. To describe the degree of the synergy between velocity and temperature gradient fields a non-dimensional parameter, named as synergy number, is defined, which represents the thermal performance of convective heat transfer. In order to explore the physical essence of the field synergy principle a new quantity of entransy is introduced, which describes the heat transfer ability of a body and dissipates during hear transfer. Since the entransy dissipation is the measure of the irreversibility of heat transfer process for the purpose of object heating the extremum entransy dissipation (EED) principle for heat transfer optimization is proposed, which states: for the prescribed heat flux boundary conditions, the least entransy dissipation rate in the domain leads to the minimum boundary temperature difference, or the largest entransy dissipation rate leads to the maximum heat flux with a prescribed boundary temperature difference. For volume-to-point problem optimization, the results indicate that the optimal distribution of thermal conductivity according to the EED principle leads to the lowest average domain temperature, which is lower than that with the minimum entropy generation (MEG) as the optimization criterion. This indicates that the EED principle is more preferable than the MEG principle for heat conduction optimization with the purpose of the domain temperature reduction. For convective heat transfer optimization, the field synergy equations for both laminar and turbulent convective heat transfer are derived by variational analysis for a given viscous dissipation (pumping power). The optimal flow fields for several tube flows were obtained by solving the field synergy equation. Consequently, some enhanced tubes, such as, alternation elliptical axis tube, discrete double inclined ribs tube, are developed, which may generate a velocity field close to the optimal one. Experimental and numerical studies of heat transfer performances for such enhanced tubes show that they have high heat transfer rate with low increased flow resistance. Finally, both the field synergy principle and the EED principle are extended to be applied for the heat exchanger optimization and mass convection optimization.

An Integrated System-Level and Component-Level Optimization of Heat Transfer Systems Based on the Heat Current Method

An Integrated Three-Level Synergetic and Reliable Optimization Method Considering Heat Transfer Process, Component, and System

A Collaborative Optimization Method for Heat Transfer Systems Based on the Heat Current Method and Entransy Dissipation Extremum Principle

Recent Progresses on Optimal Design of Heat Integrated Water Allocation Network

Thermohydraulic Performance Optimization of Integrated Porous Pin Fins in Microchannel Heat Sink Using Shape Optimization Coupled with NSGA

Heat Current Method for Integrated Analysis and Optimization of Thermodynamic Systems

An Integral Identification Method of Characteristic Parameters and Optimization of Parallel Connection Heat Transfer Systems Based on the Power Flow Method

An Innovative Self-Adaptive Method for Improving Heat Sink Utilization Efficiency of Hydrocarbon Fuel in Regenerative Thermal Protection System of Combined Cycle Engine

Heat Current Method for Analysis and Optimization of Heat Recovery-Based Power Generation Systems

Optimization Strategies of Heat Transfer Systems with Consideration of Heat Transfer and Flow Resistance

Multi-scale simulation and optimization on a thermal management system of intermediate circuit and experiment validation

Integrated Optimization of Heat-Transfer Systems Consisting of Discrete Thermal Conductors and Solid Material

Optimization Principles For Heat Convection

Design and Performance Enhancement of Thermal-Fluid System Based on Topology Optimization

A synergic topology optimization approach on distribution of cooling channels and diverse-intensity heat sources for liquid-cooled heat sink

A Transient Heat Current Model for Dynamic Performance Analysis and Optimal Control of Heat Transfer System

Power Flow Method-Based Integrated Modeling and Optimization for Building Heat Transport and Gas Refrigeration System

Systematic Optimization of Heat-Integrated Water Allocation Networks

A Novel Optimization Framework for Designing Multi-Stream Compact Heat Exchangers and Associated Network

The Power Flow Method for Analysis and Optimization of Heat Recovery and Power Generation System

A Global Sensitivity Analysis-Assisted Sequential Optimization Tool for Plant-Fin Heat Sink Design