Effect of Nano-Tic/tib2 on Recrystallization, Texture and Mechanical Properties of Al–Cu–Li Alloy During Solid-Solution Treatment
Haiyao Wang,Beibei Li,Yong Li,Wei Yu,Yin Wang,Bing Lu,Jiadong Li,Guangming Xu
DOI: https://doi.org/10.1016/j.jmrt.2023.09.213
IF: 6.267
2023-01-01
Journal of Materials Research and Technology
Abstract:The evolution of the microstructure, texture and mechanical properties of the Al-Cu-Li alloy sheets by nanoscale TiC + TiB2 ceramic particles during solid solution treatment was systematically investigated by characterization, texture measurements and mechanical performance tests. The yield strength, tensile strength, and elongation of the A1 alloy with the addition of nanoscale TiC + TiB2 ceramic particles under T4P conditions were 312 MPa, 420 MPa, and 21.9%, respectively, which were 35.6%, 27.6%, and 2.8% higher than those of the A0 alloy, respectively. The recrystallization mechanism of both alloys was mainly the particle stimulated nucleation (PSN) mechanism, but the nanoscale TiC + TiB2 in the A1 alloy led to a stronger Zener dragging effect, which hindered the growth of CubeND nuclei, and P-oriented grains dominated. Thus, the A0 alloy sheet was dominated by CubeND components, while the A1 alloy sheet was dominated by P recrystallized grains, which led to the two alloy sheets showing opposite variation trends of the deep drawing properties with increasing solid solution treatment time. The short-time solid-solution process is more likely to provide better properties to the alloy with TiC + TiB2 added particles better properties in terms of various aspects, such as microstructure, mechanical properties, and electrical conductivity. (c) 2023 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).