Effect of MOx (M = Ce, Ni, Co, Mg) on Activity and Hydrothermal Stability of Pd Supported on ZrO2–Al2O3 Composite for Methane Lean Combustion

Yang Wu,Guangxia Li,Wei Hu,Fujin Huang,Jianjun Chen,Lin Zhong,Yaoqiang Chen
DOI: https://doi.org/10.1016/j.jtice.2018.01.038
IF: 5.477
2018-01-01
Journal of the Taiwan Institute of Chemical Engineers
Abstract:Zr0.5Al0.5O1.75 (ZA) was modified by metal oxide (Ce, Co, Ni or Mg oxide) via double solvent method. The Pd nanoparticles were supported on the modified ZA and then tested for methane lean combustion. The textural, structural and redox properties, surface Pd oxidation states and stability of the samples were investigated systematically. The modified catalysts were aged in the 750 degrees C humid air (10 vol.% water vapor) for 10 h, namely aging treatment. It was found that the activity and hydrothermal stability of the Pd/ZA catalyst was enhanced after the addition of NiO, MgO or Co3O4. Particularly, the Pd/NiO/Zr0.5Al0.5O1.75 (Pd/NiO/ZA) catalyst exhibited the best performance for methane combustion in the presence of water vapor, regardless of aging treatment. X-ray diffraction (XRD) patterns showed that the presence of spinel phase in the PcI/NiO/ZA. CO-chemisorption results demonstrated the highest Pd dispersion on the fresh and aged Pd/NiO/ZA. H-2-temperature-programmed reduction (H-2-TPR) measurements indicated that the Pd/NiO/ZA catalyst possessed the best reducibility regardless of aging treatment. X-ray photoelectron spectroscopy (XPS) analysis and temperature-programmed oxidation (TPO) experiments revealed that the Pd/NiO/ZA catalyst possessed the highest active phase PdO content and stability. Consequently, the PcI/NiO/ZA catalyst would be promisingly applied to exhaust after-treatment for lean-burn natural gas vehicles. (C) 2018 Taiwan Institute of Chemical Engineers. Published by Elsevier B.V. All rights reserved.
What problem does this paper attempt to address?