Abstract:Abstract 1,3‐Dienes/styrene sequence‐controlled copolymers are widely used as thermoplastic elastomers, transparent impact resin and synthetic rubber and other materials. In this work, the binary anionic copolymerization of styrene ( S ) and C5‐dienes including 1,3‐pentadiene ( P , E / Z = 65/35) and isoprene ( I ) were studied in cyclopentyl methyl ether (CPME) ‘green’ solvent using n ‐BuLi as initiator, and the effects of copolymerization monomer ratio and polar additive (PA) on the copolymerization kinetics and monomer sequence distributions were investigated. The kinetic analysis results showed that all copolymerization systems were the first‐order reaction and the C5‐dienes/ S could be quantitatively consumed. The addition of S or I was conducive to the efficient conversion of P . Although the addition of PAs had little effect on the polymerization rate, it had a great influence on the microstructure and sequence distribution of the copolymer. 1 H NMR tracking analysis showed that, for S/P copolymerization with different feeding ratios 1/3 < f P < 2/3, the instant composition F P in the copolymer remained relatively constant at 15% < F P < 35% when the monomer conversion rate was below 60%, and thus the inevitable formation of P microblocks in subsequent polymerization sequences was observed. Additionally, similar sequence distributions were obtained in the case of I/P copolymerization systems. By contrast, S / I copolymerization conformed to the typical random copolymerization pattern, and the copolymerization activity of S was slightly higher than that of the I in CPME. The use of strong PAs such as 2,2‐di(2‐tetrahydrofuran)propane directly resulted in a change of monomer sequence from a random pattern to a gradual block pattern. Moreover, the 3,4‐isoprene branch units were much more sensitive to solvent and PA than 1,2‐pentadiene units for C5‐dienes; also Fourier transform infrared and DSC analysis verified the microstructure and sequence analysis results mentioned above. In addition, the results of gel permeation chromatography showed that the copolymerization process in CPME had excellent controllable characteristics. © 2023 Society of Industrial Chemistry.

Facile Synthesis Of Ethylene-Propylene Fully Alternating Copolymer And Comparison With Random Copolymer Of Similar Composition

Engineering Ethylene/1-Hexene Copolymers from Ethylene Stock with a Model-Guided Catalyst Feeding Policy

Preparation Of Comb-Shaped Polyolefin Elastomers Having Ethylene/1-Octene Copolymer Backbone And Long Chain Polyethylene Branches Via A Tandem Metallocene Catalyst System

Novel Polyethylene‐b‐polyurethane‐b‐polyethylene Triblock Copolymers: Facile Synthesis and Application

Structure Analysis of Ethylene/1-Octene Copolymers Synthesized from Living Coordination Polymerization

Dynamic Mechanical and Rheological Properties of Metallocene-Catalyzed Long-Chain-Branched Ethylene/Propylene Copolymers

Thermal and Mechanical Properties of Ultrahigh-Molecular-Weight Ethylene/1-Hexene Copolymers Prepared by Living Polymerization with Fluorinated Bis(Phenoxy-Imine) Titanium(Iv) Catalyst

Synthesis of Ethylene/1‐octene Copolymers with Controlled Block Structures by Semibatch Living Copolymerization

Effect of Catalysts Supporting on Tandem Polymerization of Ethylene Stock in Synthesis of Ethylene-1-Hexene Copolymer

Synthesis of Polyethylene-G-polydimethylsiloxane Graft Copolymers by Copolymerization of Ethylene with Polydimethylsiloxane Macromonomer

Macromol. Rapid Commun. 3/2015

Ethylene-Ethyl Acrylate Copolymers Via Admet Polymerization: Effect Of Sequence Distribution On Thermal Properties

Microstructure of Ethylene/propylene Random Copolymers Prepared by a Fluorinated Bis(phenoxy-Imine) Ti Catalyst

13C NMR Studies of Ethylene-Propylene Copolymers Prepared with Homogeneous Metallocene-Based Ziegler-Natta Catalysts

Thermal fractionation and effect of comonomer distribution on the crystal structure of ethylene–propylene copolymers

Crystallization Behavior of Poly(styrene–ethylene) Copolymers Prepared by Sequential Polymerization

The Effect of Feeding Sequence on the Structure and Properties of the Ethylene/1-Octene Copolymer in the Semi-Continuous Polymerization Reaction System

Synthesis, kinetic study and characterization of C5 ‐dienes/styrene copolymers via living anionic polymerization in cyclopentyl methyl ether solvent

CRYSTALLIZATION KINETICS OF ETHYLENE-PROPYLENE COPOLYMERS PREPARED BY LIVING COORDINATION POLYMERIZATION

1,3-Pentadiene-Assistant Living Anionic Terpolymerization: Composition Impact on Kinetics and Microstructure Sequence Primary Analysis

Synthesis of Polypropylene/poly(ethylene-co-propylene) In-Reactor Alloys by Periodic Switching Polymerization Process: Dynamic Change of Gas-Phase Monomer Composition and Its Influences on Polymer Structure and Properties