Nano-Porous Structural Evolution and Tectonic Control of Low-Medium Metamorphic Tectonically Deformed Coals—Taking Suxian Mine Field as an Example

Yu Song,Bo Jiang,Ming Li,Jie-Gang Liu,Guo-Xi Cheng,Zheng Tang
DOI: https://doi.org/10.1166/jnn.2017.14476
2017-01-01
Journal of Nanoscience and Nanotechnology
Abstract:Nanostructure morphology (0.1 similar to 100 nm) evolution and its tectonic control of low-medium metamorphic tectonically deformed coals (TDC) collected from Huaibei mine were investigated using scanning electron microscopy (SEM), high-pressure mercury intrusion (HPMI), and low-pressure gas adsorption (LP-N-2/CO(2)GA). The results indicate that macro and meso pores with a diameter of 6.78 nm account to most of the specific surface area (SSA), whereas those with a diameter of 40 nm amount to most of the pore volume (PV). Nano-porous SSA is dominant by the pores with diameter less than 1.0 nm. Affected by strong tectonic stress, nano-pores have suffered from intense tectonic reformation. During the sequence of brittleness similar to brittlenes-ductileness similar to toughness: (1) Fine bottleneck pores (3.3 similar to 4 nm) gradually increase and reach to the most in schistose and wrinkle coals, while open parallel plate-pores (> 10 nm) reduce and disappear in wrinkle coals. (2) With a sharply increase in wrinkle coals, the SSA and PV of nano-pores increase gradually, among which that of macro-and meso pores increase slowly during brittleness similar to brittlenes-ductileness nevertheless rapidly during brittleness-ductileness similar to toughness sequence. (3) Median pore diameter (MPD) gradually decreases and pore shapes (PS) become more complicated. (4) With a significant increase in the percentage of pores between 0.1 and 0.7 nm, decrease of pores between 0.7 similar to 1.0 nm and stabilization of pores between 0.1 and 2.0 nm, the SSA and PV, dominated by the pores between 0.1 and 0.7 nm, of micropores reduce gradually and is sensitive to the tectonic deformation. Pores smaller than about 0.7 nm and that between 0.868 and 1.7 nm are corresponding aromatic interlayer pores and cylindrical pores respectively formed by the ordered stacking of aromatic. Cataclastic process promotes the reduction of MPD in nano-pores and increasing the SSA in micro pores. This results in rapid decrease of MPD amplitude and increase in SSA amplitude especially in micro pores. Shear process urges the appearing of fine bottleneck pores and disappearing of parallel plate-pores simultaneously in schistose coals. Strong shear deformation may act as an important factor affecting the micropores in scaly coals, both parallel plate-and bottleneck pores appear along with a MPD slightly larger than schistose coals. Wrinkle process can significantly promote the transformation from micron-porous to nano-porous, leading to a large MPD decrease and SSA increase.
What problem does this paper attempt to address?