Abstract:Steel slags are solid residual materials formed as by-products throughout the process of steel production within the steelmaking industry. These wastes have good physical properties such as high stiffness and friction angle for use as road fill materials or in geotechnical applications. However, the presence of heavy metals and high alkalinity levels constitute significant environmental hazards and set limitations on using slags in engineering applications. While there have been investigations into the mechanical characteristics of steel slags, research on assessing potential harm when utilizing the materials in engineering applications is rare. This study examines the mitigation methods to address the environmental problems associated with steel slags. To do this, two different steel slags with different production techniques were treated with soils of different properties such as fine and coarse sand, bentonite, kaolin, and natural clay. The pH and electrical conductivity (EC) values of pure steel slags were determined using the water leach test (WLT). Variations in pH and EC values of steel slags subjected to treatment were evaluated through both WLT and sequential water leach (SWLT) tests. As a result, the high strength, stiffness, and drainage capability of EAF and LS steel slags make these materials suitable for road filling. This is further backed by their soaked and unsoaked CBR values. During the water leach tests, notable decreases in pH were observed with a 60% natural clay (NC) solution, resulting in a decrease of 1.2 and 0.7 in EAF and LS, respectively. The addition of sand had a negligible impact on pH due to its inert characteristics. Moreover, in sequential water leach tests, the most significant decrease in pH was observed with NC (with a reduction of 2.0 points for EAF and 0.9 points for LS) through enhanced ion exchange and extended periods of dilution and buffering. Also, the use of NC resulted in substantial decreases in EC for EAF and LS, with reductions of 77% and 81%, respectively. Moreover, heavy metal concentrations in leachate waters from pure steel slags have been detected, and the effect of treatment on aluminum and iron concentrations has been determined. The results indicate that the use of natural soil significantly drops the pH and lowers the trace metal concentrations within the leachate.

Physicochemical Properties of Arsenic-Bearing Lime–ferrate Sludge and Its Leaching Behaviors

A Comparative Study on Stabilization of Available As in Highly Contaminated Hazardous Solid Waste.

Efficient stabilization of arsenic in the arsenic-bearing lime-ferrate sludge by zero valent iron-enhanced hydrothermal treatment

Transformation of Arsenic During Realgar Tailings Stabilization Using Ferrous Sulfate in a Pilot-Scale Treatment.

Characterisation of arsenic levels in acid-treated arsenic-containing sludge after steel slag-fly ash gel curing

Risk assessment for the long-term stability of fly ash-based cementitious material containing arsenic: Dynamic and semidynamic leaching

Long-term stability of arsenic calcium residue (ACR) treated with FeSO4 and H2SO4: Function of H+ and Fe(II)

Iron-calcium reinforced solidification of arsenic alkali residue in geopolymer composite: Wide pH stabilization and its mechanism

Minimization and stabilization of smelting arsenic-containing hazardous wastewater and solid waste using strategy for stepwise phase-controlled and thermal-doped copper slags

Stabilization of Arsenic in Waste During Co-Processing with Cement Kiln and Leaching Characteristics of Clinker

Innovative methodology for comprehensive utilization of arsenic-bearing neutralization sludge

Stabilization of calcium arsenic residues via the formation of ferrous/ferric arsenate

Removal Of Arsenic(Iii) From Aqueous Solution Using A Low-Cost By-Product In Fe-Removal Plants-Fe-Based Backwashing Sludge

Influence of Ferric Chloride on Chemical Stabilization of Calcium Arsenate Residuals

An all-in-one strategy for resource recovery and immobilization of arsenic from arsenic-bearing gypsum sludge

Effect of pH, competitive anions and NOM on the leaching of arsenic from solid residuals

Evaluation of chemical immobilization treatments for reducing arsenic transport in red mud

COMPARISON OF THE STABILIZING CAPABILITIES OF IRON AND ALUMINUM IN TREATING WASTE HIGHLY CONTAMINATED WITH ARSENIC

Waste Control by Waste: Co-Treatment of Municipal Solid Waste Incineration Fly Ash and High Arsenic-Containing Wastewater

Disposal of high-arsenic waste acid by the stepwise formation of gypsum and scorodite

Utilization of Natural Soils as a Remediation Method for Electric Arc Furnace and Ladle Slags