Abstract:The composite of samarium doped ceria (Sm0.2Ce0.8O2-delta, SDC) and co-doped barium cerate (BaZr0.1Ce0.7Y0.1Yb0.1O3-delta, BZCYYb) is prepared by mechanical mixing and investigated as electrolyte for intermediate temperature solid oxide fuel cells (IT-SOFCs). Coexistence of SDC and BZCYYb are observed for composite electrolyte by X-ray diffraction after sintering at 1500 degrees C for 5 h, while the slight deviation of the diffraction peak indicating the element diffusion between two phases. The scanning electron microscope and electron probe microanalyzer results demonstrate that small BZCYYb grains disperse uniformly around the grains of SDC, limiting the growth of SDC grains and decreasing the average grain size of composite electrolyte. Impedance spectroscopy measurement reveals that the grain boundary resistance can be significantly reduced by about an order of magnitude through adding 15-30 wt. % BZCYYb to SDC. Single cells based on the composite electrolyte are fabricated using nickel cermet (Ni-SDC) anode and perovskite (La0.6Sr0.4Co0.2Fe0.8O3-delta, LSCF) cathode. Relatively high open circuit voltage (OCV), much lower polarization resistance and encouraging high power density are obtained for cells with composite electrolyte compared to those with single SDC electrolyte. Among all of the samples, single cell based on 15 wt. % BZCYYb-85 wt. % SDC composite electrolyte exhibits the lowest total resistances of 0.641 Omega.cm(2) and the highest peak power densities of 0.56 W. cm(-2) at 600 degrees C. (C) 2018 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.

Interfacial Effects On Electrical Conductivity In Ultrafine-Grained Sm0.2ce0.8o2_(Delta) Electrolytes Fabricated By A Two-Step Sintering Process

Interfacial effects on electrical conductivity in ultrafine-grained Sm0.2Ce0.8O2−δ electrolytes fabricated by a two-step sintering process

Grain boundary conduction behaviors of ultra-fine grained CeO2/BaCeO3 based electrolytes

Synthesis and Sintering of Gd-Doped Ceo2 Electrolytes with and Without 1 At.% Cuo Dopping for Solid Oxide Fuel Cell Applications

Effect of Al2O3 Doping Method on the Properties of Ce0.8Sm0.2O1.9 Electrolyte

Densification of Sm0.2Ce0.8O1.9 with the Addition of Lithium Oxide As Sintering Aid

Composite Electrolyte Based On Nanostructured Ce0.8sm0.2o1.9 (Sdc) For Low-Temperature Solid Oxide Fuel Cells

A High Performance Interconnecting Ceramics for Solid Oxide Fuel Cells (Sofcs)

Effect of agglomeration on the densification properties of Sm0.15Gd0.05Ce0.8O1.9 electrolytes for intermediate temperature solid oxide fuel cells

Preparation and characterization of nanocrystalline Ce0.8Sm0.2O1.9 for low temperature solid oxide fuel cells based on composite electrolyte

Influence of the Sintering Temperature on Electrical Property of the Ce0.8Sm0.1Y0.1O1.9 Electrolyte

Effects of Co-Doped Barium Cerate Additive on Morphology, Conductivity and Electrochemical Properties of Samarium Doped Ceria Electrolyte for Intermediate Temperature Solid Oxide Fuel Cells

Influence of Lithium Oxide Addition on the Sintering Behavior and Electrical Conductivity of Gadolinia Doped Ceria

Understanding the Flash Sintering of Rare‐Earth‐Doped Ceria for Solid Oxide Fuel Cell

Sintering of Ce0.8Sm0.2O1.9

Effect of MgO and Fe2O3 Dual Sintering Aids on the Microstructure and Electrochemical Performance of the Solid State Gd0.2Ce0.8O2-δ Electrolyte in Intermediate-Temperature Solid Oxide Fuel Cells

Understanding the Sintering Temperature Effect on Oxygen Ion Conductivity in Doped Ceria Electrolytes

Effects of Nio on the Conductivity of Ce0.85sm0.15o1.925 and on Electrochemical Properties of the Cathode/Electrolyte Interface

Preparation and Electrical Behavior Study of the Ceramic Interconnect La0.7Ca0.3CrO3−δ with CeO2-based Electrolyte Ce0.8Sm0.2O1.9

Effect of Al2O3 addition on sintering behavior and properties of Ce0.8Sm0.2O1.9 electrolytes

Sintering of Ce（0.8）Sm（0.2）O（1.9）