N_2O Catalytic Decomposition over Mixed Oxides Derived from Zn-substituted Hydrotalcite-like Compounds
Yu Jun-Jie,Zhu Ling,Zhou Bo,Shao Yu-Nan,Mang Yu-Ting,He Xu-Wen
DOI: https://doi.org/10.3866/pku.whxb20090227
2009-01-01
Abstract:A series of hydrotalcite-like precursors with different Zn contents of ZnxMg3-xAl-HT (x=0, 0.5, 1.0, 1.5, 2.0, 2.5, 3.0) were synthesized by co-precipitation methods, and by keeping the atomic ratio of M2+/M3+ constant at 3. Mixed oxides derived from these precursors through calcination were applied to NO catalytic decomposition. X-ray diffraction (XRD), BET surface area, thermal analysis (TG-DSC), and Fourier transform infrared (FT-IR) techniques were used to study the influence of Zn content on the composition and structure of precursors and corresponding mixed oxides. N2O catalytic decomposition behavior over ZnxMg3-xAlO catalysts was investigated and impacts of reaction conditions, such as N2O concentration, space velocity, O-2 and H2O on catalytic activity, were studied in detail. The results showed that the complete hydrotalcite layer structure was formed in all precursors. After calcination the main catalyst phase is Zn-Al spinel. The introduction of Zn promotes the formation of the spinel. Mg can improve the thermal stability of catalysts to some degree. Zn content has an important influence on the thermal stability, surface area and activity of the catalyst. As Zn content increases the surface area of the catalyst decreases. Surface area is, however, not an important factor in N2O catalytic decomposition, Zn2.0Mg1.0AlO catalyst, calcined at 650 degrees C, shows relatively good activity for N2O decomposition. The N2O concentration, space velocity, and 0, have little impact on activity, while H2O obviously influences the activity of N2O catalytic decomposition.