Abstract:Methyl decanoate, methyl-5-decenoate and methyl-9-decenoate have been widely adopted as biodiesel surrogates for engine simulation. However, these surrogates have relatively short chain length and very different physical properties compared with biodiesel molecules. Additionally, it is difficult to distinguish the unsaturafion degree of different biodiesel fuels by using these surrogates. The direct use of the heavy methyl esters in real biodiesel fuels as surrogates is essential to accurately simulate biodiesel fuels. In this work, a four-part scheme to formulate skeletal mechanism for heavy saturated methyl esters has been proposed. Within the scheme, the oxidation mechanism is divided into four parts: low temperature oxidation, high temperature decomposition, ester group reactions and detailed C4-C0 chemistry. A skeletal mechanism for two of the five main methyl esters in real biodiesel fuels, i.e. saturated methyl palmitate and methyl stearate, has been constructed. The obtained skeletal mechanism contains only 6 fuel-dependent species and 13 fuel-dependent reactions for each heavy saturated methyl ester. Extensive validations were performed against shock tube experimental data for ignition delay timing under different initial pressure, temperature and equivalence ratio. The ignition delay behavior at high temperature has been well captured by the developed skeletal mechanism. As for ignition at low to medium temperature (from 650 K to 900 K), there is no experimental data due to the low vapor pressure and high melting point of heavy methyl esters. The comparison of ignition behavior at low temperature has been made between several models. Furthermore, the oxidation of n-decane/methyl palmitate and benzene/methyl stearate in a jet-stirred reactor has been utilized to validate the important species concentration. Good agreements have been observed through the validations. The results indicate that the developed skeletal mechanism is capable of predicting the combustion characteristics of methyl palmitate and methyl stearate.

Speed of Sound in Methyl Caprate, Methyl Laurate, and Methyl Myristate: Measurement by Brillouin Light Scattering and Prediction by Wada’s Group Contribution Method

Measurement of sound speed in methyl caprate, methyl laurate and methyl myristate

Measurement of Sound Speed and Derived Properties of Three FAMEs

Measurement of the Speed of Sound in Methyl Caprylatefrom 298.22 to 608.38 K and up to 10 MPa

Speed of Sound Measurement and Prediction of Ethyl Hexanoate and Ethyl Octanoate at Temperatures from (293.15 to 473.15) K and Pressures from (0.1 to 10) MPa

Speed of Sound Measurements and Thermophysical Modeling of Binary Mixtures of Methyl Laurate and N-Dodecane

Measurement and prediction of the speed of sound of biodiesel fuels

Measurement and prediction of speed of sound of three FAEEs

Measurement of Speed of Sound and Thermal Diffusivity of Ethyl Heptanoate Using Light Scattering Method

Speed of Sound and Thermal Diffusivity of Ethyl Myristate

Measurement and prediction of speed of sound in ethyl decanoate

Measurement of Speed of Sound in Methyl Hexanoate from 297.83 to 588.07 K and Up to 10 MPa

Experimental Investigations on the Liquid Thermal Conductivity of Five Saturated Fatty Acid Methyl Esters Components of Biodiesel

Measurement and Correlation of the Density, Viscosity and Vapor Pressure of Fatty Acid 2-Ethyhexyl Esters

Speed Of Sound And Derived Properties Of Ethyl Nonanoate

Speed of Sound Measurement in Ethyl Tert-Butyl Ether and Tert-Amyl Methyl Ether by Brillouin Light Scattering

Volumetric Properties of Binary Mixtures of Methanol with Ethyl Caprylate, Ethyl Caprate, and Ethyl Laurate from 283.15 to 318.15 K

Speed of Sound and Derivative Properties of Ethyl Laurate from Rayleigh–Brillouin Light-Scattering Spectroscopy

Skeletal Mechanism Construction for Heavy Saturated Methyl Esters in Real Biodiesel Fuels

Measurement on the Thermal Conductivity of Five Saturated Fatty Acid Ethyl Esters Components of Biodiesel

On the Laminar Flame Propagation of C5H10O2 Esters Up to 10 Atm: A Comparative Experimental and Kinetic Modeling Study