Abstract:Gas sensing by optical methods employs traditionally conventional broadband radiation sources or narrowband lasers to take advantage of the specific absorption spectra of the studied gas. The gas correlation spectroscopy (COSPEC) technique is particularly simple and immune to spectral interference because it utilizes a reference gas cell to recognize and quantify the amount of the same gas in the sample volume. This technique can be used in monitoring industrial and volcanic emissions by employing various light sources, including thermal background radiation, broadband lasers, light emitting diodes (LED) and multi-mode diode lasers. Recently, LEDs with structureless emission in the UV region have become available. This paper demonstrates that LEDs can be ideal sources for gas absorption measurements combined with the gas correlation technique, especially suitable for industrial emission monitoring.The LED employed is centered around 300 nm and has an emission band width of about 12 nm covering about 8 prominent absorption peaks of SO2.By using a 19-cm long sample gas cell, an Allan variance analysis predicted a sensitivity of 0.4 ppm (1.1 mg/m3) with an integration time of one minute. The obtained sensitivity is sufficient for industrial emissions monitoring where typical SO2 concentrations range from tens to thousands of ppm. For atmospheric monitoring applications at ppb level long path absorption or a multi-pass cell can be employed. The system is immune from interfering gases, such as NO2, and it is also largely insensitive to total pressure variations and light intensity fluctuations.

Optical sulfur dioxide sensor based on broadband absorption spectroscopy in the wavelength range of 198–222 nm

Using broadband absorption spectroscopy to measure concentration of sulfur dioxide

Concentration Evaluation Method Using Broadband Absorption Spectroscopy for Sulfur Dioxide Monitoring

System for Simultaneous Sensing of Sulfur Dioxide and Carbon Disulfide Based on Deep Ultraviolet Absorption Spectroscopy

Broadband Spectroscopic Sensor for Real-Time Monitoring of Industrial SO_2 Emissions

Real-time Monitoring of Sulfur Dioxide Using Ultraviolet Light-Emitting Diode

Ppm-level Oxygen Detection System Based on Deep-Ultraviolet-absorption Spectroscopy

A Measurement Technique of SO2 Concentration Using Broadband Absorption Spectroscopy

All-diode-laser Ultraviolet Absorption Spectroscopy for Sulfur Dioxide Detection

Optical H 2 S and SO 2 sensor based on chemical conversion and partition differential optical absorption spectroscopy.

Sulfur dioxide measurements by correlation spectroscopy using an ultraviolet light-emitting diode

Simultaneous Measurement of SO 2 and NO 2 Concentration Using an Optical Fiber-Based LP-DOAS System

Sensitive Dual Sensing System for Oxygen and Pressure Based on Deep Ultraviolet Absorption Spectroscopy

Sulfur dioxide measurements using an ultraviolet light-emitting diode in combination with gas correlation techniques

Study of SO2 Measurement Based on a Dual Optical Path Fabry-Perot Correlation Spectroscopy

An ultra-sensitive optical H 2 S sensor based on thermal conversion combined with UV-DOAS: Dynamic detection from ppm to ppb level

Quantum Cascade Laser Absorption Sensor for In-Situ, Real-Time and Sensitive Measurement of High-Temperature SO2 and SO3

Detection of Sulfur Dioxide by Broadband Cavity-Enhanced Absorption Spectroscopy (BBCEAS)

An Optical Fiber Sensor Based on Absorption Spectroscopy for Carbon Monoxide Detection

An Optical System for Measuring Nitric Oxide Using Spectral Separation Techniques

Highly-sensitive Carbon Disulfide On-Line Detection System Based on Deep Ultraviolet Absorption Spectroscopy, and Its Application in Liquid-Seal Reliability Assessment.