Abstract:Simultaneous detection of carbon dioxide (CO2) and oxygen (O2) has attracted considerable interest since CO2 and O2 play key roles in various industrial and domestic applications. In this study, a new approach based on a fluorescence ratiometric referencing method was reported to develop an optical dual sensor where platinum (II) meso-tetrakis(pentafluorophenyl)porphyrin (PtTFPP) complex used as the O2-sensitive dye, CdSe/ZnS quantum dots (QDs) combined with phenol red used as the CO2-sensitive dye, and CdSe/ZnS QDs used as the reference dye for the simultaneous detection of O2 and CO2. All the dyes were immobilized in a gas-permeable matrix poly (isobutyl methacrylate) (PolyIBM) and subjected to excitation using a 380 nm LED. The as-obtained distinct fluorescence spectral intensities were alternately exposed to analyte gases to observe changes in the fluorescence intensity. In the presence of O2, the fluorescence intensity of the Pt (II) complex was considerably quenched, while in the presence of CO2, the fluorescence intensity of QDs was increased. The corresponding ratiometric sensitivities of the optical dual sensor for O2 and CO2 were approximately 13 and 144, respectively. In addition, the response and recovery for O2 and CO2 were calculated to be 10 s/35 s and 20 s/60 s, respectively. Thus, a ratiometric optical dual gas sensor for the simultaneous detection of O2 and CO2 was successfully developed. Effects of spurious fluctuations in the intensity of external and excitation sources were suppressed by the ratiometric sensing approach.

Sensitive Dual Sensing System for Oxygen and Pressure Based on Deep Ultraviolet Absorption Spectroscopy

Ppm-level Oxygen Detection System Based on Deep-Ultraviolet-absorption Spectroscopy

Highly Sensitive Trace Oxygen Sensing Based on Far-Ultraviolet Absorption Spectroscopy

High Sensitivity Photoelectric Pressure Sensor Based on A Monolithic Dual Photodiode

A Highly Sensitive and Flexible Photonic Crystal Oxygen Sensor

Sensitive Detection of Oxygen Using a Diffused Integrating Cavity As a Gas Absorption Cell

System for Simultaneous Sensing of Sulfur Dioxide and Carbon Disulfide Based on Deep Ultraviolet Absorption Spectroscopy

Optical sulfur dioxide sensor based on broadband absorption spectroscopy in the wavelength range of 198–222 nm

Highly sensitive detection of oxygen based on light-induced thermoelastic spectroscopy with a high power diode laser

Highly Sensitive Measurement of Oxygen Concentration Based on Reflector-Enhanced Photoacoustic Spectroscopy

Environmental oxygen monitoring in confined spaces by a mobile sensor system based on OA-ICOS and PSO-SVM without pressure control

A Ratiometric Optical Dual Sensor for the Simultaneous Detection of Oxygen and Carbon Dioxide

Assessing Surface Air Pressure Sensing Using 118 GHz O2-absorption Radar System

Research on Highly Sensitive Detection of Oxygen Concentrations Based on Tunable Diode Laser Absorption Spectroscopy

Pressure-Dependent Detection of Carbon Monoxide Employing Wavelength Modulation Spectroscopy Using a Herriott-Type Cell

&Lt;title>numerical Analysis on Oxygen Saturation Measurement by Dual-Wavelength Optical Low-Coherence Interferometry</title>

Concentration Evaluation Method Using Broadband Absorption Spectroscopy for Sulfur Dioxide Monitoring

Optical Micro-Electro-Mechanical-System Pressure Sensor Based on Light Intensity Modulation

Development of a Stable Oxygen Sensor Using a 761 nm DFB Laser and Multi-Pass Absorption Spectroscopy for Field Measurements

Development and measurement of airborne oxygen sensor for aircraft inerting system based on TDLAS with pressure compensation and 2f/1f normalized method

Design and Performance Evaluation of a Deep Ultraviolet LED-Based Ozone Sensor for Semiconductor Industry Applications