Abstract:The electrical explosion of metal wire plays significant role in many applications, such as synthesis of nanopowder, dense plasma generation and wire-array Z pinch1, etc. In the initial stage of the wire-array Z pinch, every single wire are exploded into core-corona structure, i.e., the high-density, low-temperature core surrounded by the high-temperature, low-density corona plasma. The plasma column has great influence on the stagnation stage of the wire-array Z pinch. The homogeneity of the plasma column is determined by the energy deposition in the metal wire. Therefore, the investigation on the energy deposition and morphology of the electrical explosion of metal wire is very important for the understanding of the physics of the wire-array Z pinch. In this paper, a set of experimental results of electrical explosion of aluminum and tungsten wires with and without insulating coatings are presented. The process of energy deposition derived from the exploding wires with and without insulating coatings are compared and analyzed. Enhanced energy deposition is achieved in exploding aluminum and tungsten wires with insulating coatings. A laser probe (EKSPLA-PL2251C, 532nm, 30ps) is applied to construct the shadowgraphy, interferometry and schlieren diagnostics to give detailed information about the morphology of the exploding products. The shadowgram and schlieren images present the morphology of the high-density core and the front of the high density gradient of the neutral atoms and plasma, respectively. The interference phase shift is reconstructed from the interferogram. The shadowgram of the exploding aluminum wire with insulating coatings demonstrate a structure of strata. Although the energy deposition in the coated tungsten wire is enhanced substantially, the shadowgram of the exploding tungsten wire with insulating coatings show a severe inhomogeneous structure of energy deposition. The barrier of the energy deposition in the exploding coated tungsten wire is analyzed.

Observation of Fast Expansion Velocity with Insulating Tungsten Wires on ∼80 Ka Facility

Evolution of the Electrically Exploding Wire Observed with a Mach–Zehnder Interferometer

Atomization and merging of two Al and W wires driven by a 1 kA, 10 ns current pulse

Transforming Dielectric Coated Tungsten and Platinum Wires to Gaseous State Using Negative Nanosecond-Pulsed-Current in Vacuum

Using of Fiber-Array Diagnostic to Measure the Propagation of Fast Axial Ionization Wave During Breakdown of Electrically Exploding Tungsten Wire in Vacuum

Suppressing the Asymmetrical Structures of the Wire Array Z-pinch

Influence of Insulating Coating on Aluminum Wire Explosions

Single wire exploding experiments on fast linear transformer driver

The Influence Of Insulating Coatings On The Energy Deposition And Plasma Morphology Of The Electrical Explosion Of Aluminum And Tungsten Wire

Explosion Symmetry Improvement of Polyimide-Coated Tungsten Wire in Vacuum on Negative Discharge Facility

Mass Density Evolution of Wire Explosion Observed Using X-Ray Backlight

Study on Electrical Explosion of Bare and Insulation Coated Tungsten Wires

X-ray Observations of Tungsten Wire Arrayz-Pinch Implosions on QiangGuang-1 Facility

Experimental Study of Surface Insulated-Standard Hybrid Tungsten Planar Wire Array Z-Pinches at "Qiangguang-I" Facility

UV Laser Probing of Imploding Wire-Array Plasmas on the Angara-5-1 Facility

Experiment measuring the energy deposition and expansion rate of exploding copper wires in vacuum using negative polarity current

Effect of Thickness of Insulation Coating on Temperature of Electrically Exploded Tungsten Wires in Vacuum

X-ray Backlighting of Wire Expansion and Plasma Merging of Z-Pinch Load with 10-40Ka/wire

Laser Shadowgraphy Diagnostics for Insulated-Ordinary Mixed Planar Wire Array Z Pinches

Study of Density Distribution of Electrical Exploding Tungsten Wire in Air

Plasma flows during the ablation stage of an over-massed pulsed-power-driven exploding planar wire array