Abstract:In this paper, we assumed that the soil layer back-silted on the surface of the river bottom was impermeable. The tidal load was treated as a large-area overload periodically applied on the silt soil layer. Taking into account the coupling loading of the water and soil, we built a model to calculate the circumferential strain of the immersed tunnel elements. By using MIDAS GTS NX finite element software, we calculated the circumferential strain in the tunnel wall direction under a tidal load. The circumferential strains of the tunnel elements in the Zhoushan immersed tunnel were continuously monitored using fiber Bragg grating sensors for 24 h. The circumferential strain increments at each monitoring position were calculated based on the change of the tide level. The results were compared with the measured increments of the circumferential strains. Based on these data, we summarized the variation pattern of the circumferential strain increments under a periodic tidal load. In addition, in this paper, we calculated the total circumferential strain distribution in the inner and outer walls in different cross-sections of the tunnel elements and identified positions that should be monitored with extra care. The results show that the calculated circumferential strain increments at each measuring position of the tunnel elements are in good agreement with the measured values. This demonstrates that the theoretical calculation model is reliable. In cross-sections of the same tunnel element, the time-dependence curves of the measured circumferential strain increments at the symmetrical measurement points are approximately consistent with each other. Tidal load-induced strain accounts for approximately 12–15% of the total strain. The correlation between circumferential strain over a cross-section and tidal level depends on the constraints on both sides of the cross-section, and stronger constraints result in weaker correlations. It is important to note that tensile strain is large along the inner wall of the middle portion of the top and bottom plates as well as along the outer wall of the sides of the bottom plate.

Thermo–hydro-ionic Transport in Sea Immersed Tube Tunnel

Thermo-Hydro-Ionic Transport in Walls of Sea Immerged Tube Tunnel

Observed response of a shield-driven tunnel to fluctuations in river stage

Chloride Transport in Undersea Concrete Tunnel

A Theoretical Model for the Circumferential Strain of Immersed Tunnel Elements under Tidal Load

Sensitivity Analysis of Different Factors in the New Pipe Curtain Freezing Method under Seepage Conditions

Tide-induced Hydraulic Response in a Semi-Infinite Seabed with a Subaqueous Drained Tunnel

Study on the durability and service life for Shenjiamen subsea immersed tube tunnel

Research on Dissipation of Excess Pore Water Pressure Caused by Shield Tunnelling

Analytical Solutions for Seepage Field of Underwater Tunnel

Analytical solutions for the steady-state seepage field in a finite seabed with a lined tunnel

Investigation of hydro-thermal variations and mechanical properties in cold region tunnels under long-term freeze–thaw cycles

Analytical solutions for seepage fields of underwater tunnels with arbitrary burial depth

Water Transport in Unsaturated Cracked Concrete under Pressure

THM model of rock tunnels in cold regions and numerical simulation

Modeling Hydroionic Transport in Cement-Based Porous Materials under Drying-Wetting Actions

Analysis of the Irreversible Strain of an Underwater Shield Tunnel Based on SHM Data

Transient heat transfer analysis of airflow in a thermal water-bearing tunnel considering airflow turbulence and surrounding rock seepage effects

Seepage stability analysis of a deep-buried tunnel in fractured rocks based on a non-Darcy hydro-mechanical coupled method

Coupled Thermal-Hydro-mechanical Modeling on Characteristics of Excavation Damage Zone Around Deep Tunnels Crossing a Major Fault

A simplified method to determine the comprehensive heat transfer quantity in subway tunnels