Hydroiodic Acid Reduced Graphene Hybrid with Δ-Mno2for Electrode Material in Supercapacitors

Xiaoqiang Peng,Junwei An,Shengming Xu,Weiliang Chen,Zhenghe Xu
DOI: https://doi.org/10.1149/2.0341606jss
IF: 2.2
2016-01-01
ECS Journal of Solid State Science and Technology
Abstract:In this paper, we report a method for the further reduction of the low-cost graphene (LG) via hydroiodic acid to synthesize graphene hybrid with varying content of delta-MnO2. Scanning electron microscope (SEM), transmission electron microscopy (TEM), and X-ray diffraction (XRD) were implemented to characterize the surface and structural properties of the reduced graphene (LGHI) and graphene-MnO2 composites (GM). It can be observed that the thickness of LGHI layers is about 10 similar to 200 nm and as-prepared GM composites have a uniform morphology possessing a honeycomb structure. XRD results indicate that MnO2 in the GM exists as a delta-crystallographic structure of low crystallinity. Cyclic voltammetry (CV) curves, galvanostatic charge/discharge (GDC) curves and electrochemical impedance spectroscopy (EIS) were utilized in a three-electrode system to systematically investigate the electrochemical performance of varying delta-MnO2 content materials. Results reveal that once the mass fraction of delta-MnO2 in GM reaches 93.1% (labeled GM-6), the specific maximum capacitance of GM was found to be 783 F/g, 496 F/g, 345 F/g and 210 F/g at a current density of 0.3 A/g, 1 A/g, 3 A/g and 10 A/g, respectively. Moreover, GM-6 maintains almost 94.5% of its original specific capacitance after 5000 continuous cycles of charge-discharge. These promising results demonstrate that GM-6 has great potential to be utilized as an electrode material for supercapacitor applications. (C) 2016 The Electrochemical Society. All rights reserved.
What problem does this paper attempt to address?